-
ContentServer
矢量控制与直接转矩控制是当前主要的两种电机变频调速控制方法，已在两相交流感应电机中得到
了应用。分析了两相不对称电机矢量控制和直接转矩控制原理以及两相三桥臂逆变器的SVPWM实现方法；
运用Matlab的Simulink建立了两相不对称交流感应电机矢量控制和直接转矩控制调速系统的仿真模型，并
对两种控制系统进行了仿真研究，给出了仿真波形，进行了特性比较．
关键词：两相电机；矢量控制；直接转矩控制；SVPWM；MATLAB；仿真(Vector Control and Direct Torque Control is currently the main method of frequency control of two motors, has been in two-phase AC induction motor has been applied. Analysis of asymmetric two-phase motor vector control and direct torque control principle and two-phase SVPWM inverter arm Bridge Implementation the use of Matlab in Simulink to establish a two-phase AC induction motor asymmetry of vector control and direct torque control modulation speed of system simulation models, and the two control system was simulated, the simulation waveform characteristics were compared. Key words: two-phase motor vector control direct torque control SVPWM MATLAB Simulation)
- 2011-06-04 17:21:25下载
- 积分：1
-
MPPT-Buck
Mppt Buck Converter Project report work.
- 2011-07-05 00:11:35下载
- 积分：1
-
Winding-Temperature-Calculate
压缩机电机绕阻温度计算，包括铜线，铝线,参数包括环境温度，冷态阻值，热态阻值，计算热态绕阻温度(winding temperature)
- 2013-10-11 13:07:32下载
- 积分：1
-
MPPTforHybridEnergySystem
太阳能MPPT算法及matlab仿真结果(MPPT for Hybrid Energy System Using Gradient Approximation and Matlab Simulink Approach)
- 2011-05-06 20:42:08下载
- 积分：1
-
111
用GAL16V8设计可变长度序列信号发生器，在掌握伪随机序列性质的基础上，设计给定长度的伪随机序列信号发生器，也即设计给定n后（n为移位寄存器的级数）最长线性反馈移位寄存器序列。并在给定n产生的最长序列的基础上，截短出课题给出的序列长度，并用FM软件对可编程器件GAL16V8进行编程，以实现长度不同的序列信号发生器。(GAL16V8 design variable-length sequence signal generator based on the master pseudo-random sequence nature, the design of a given length pseudo-random sequence
Signal generator, designed for the series) up to linear feedback shift register sequences given n (n is the shift register. And given n
Sequence length given by the subject on the basis of the longest sequence, truncated, and FM software for programming the programmable device GAL16V8, in order to achieve
Different length of the sequence signal generator.)
- 2012-03-28 08:38:15下载
- 积分：1
-
基于DFT的MIMO-OFDM系统的信道估计算法研究代码
说明： MIMO系统仿真 ＭＩＭＯ技术可Ｗ极大地提升系统吞吐量和有效抵抗多径衰落的影响，被视作ＬＴＥ的核也技术之一。信号检测模块又是ＭＩＭＯ系统中非常重要的一步，因为接收端收到的信号是经历了无线信道衰落影响的信号，与发送端发送的初始值之间差距较大，因此，在接收端首先应进行信道估计求出信道矩阵Ｈ，然后根据该信道矩阵的信息，从接收端还原出发送信号。因此，在ＭＩＭＯ系统中信号检测直接彰响着系统系能的提升。本章将先介绍高移动性ＭＩＭＯ无线信道的建模方法(simulation of MIMO-OFDM communication system)
- 2021-04-11 19:58:57下载
- 积分：1
-
kongzaibingwang
双馈变速恒频风力发电系统的空载并网控制策略(Doubly-fed VSCF wind power generation system of no-load and network control strategies)
- 2008-05-09 17:52:54下载
- 积分：1
-
VegaPrime
一篇绝好的论文，主要参数VP中多坐标系的关系，包括地心坐标系，地面坐标系，投影坐标系之间的关系(An excellent paper, the main parameters of VP in the relationship between multi-coordinate system, including the geocentric coordinate system, the ground coordinate system, projection coordinates the relationship between)
- 2009-06-06 09:09:35下载
- 积分：1
-
A_DCT_based_embedded_image_coder
基于DCT的嵌入式图像编码，是DCT图像编码的经典文章，由EZW算法启发而发表的此文章。(DCT-based embedded image coding, DCT image coding is a classic article, inspired by the EZW algorithm published this article.)
- 2009-06-02 23:17:41下载
- 积分：1
-
TCC8920_STBM_D3084_SV1.0
SCHEMETICS OF TCC8020 BASED
- 2012-09-19 15:54:44下载
- 积分：1
