-
pts2
pts降低正交频分复用ofdm的峰均比论文
(Pts is to reduce the frequency in the papers are better than to as remultiplexing
)
- 2010-05-28 22:57:18下载
- 积分：1
-
FIR
1、系统仅处于训练状态。训练序列为2cos(2π×f1×n/fs)，
干扰为sin(2π×f2×n/fs)；序列长度为100个样点。
其中n=0…99，f1=1kHz，f2=2kHz，fs=8kHz。
2、采用LMS算法，均衡器输入为训练序列加上干扰，均衡器阶数为21阶，步长因子β=0.01。
3、在Matlab中编写浮点LMS算法，绘制均衡器的输出波形，并与训练序列进行对比。
(1, the system only in the training status. The training sequence is 2cos (2πf1n/fs), interference sin (2πf2n/fs) sequence length of 100 samples. Where n = 0 ... 99, f1 = 1kHz, f2 = 2kHz, fs = 8kHz. 2, using LMS algorithm, the input to the equalizer training sequence plus interference equalizer order is 21 bands, step factor β = 0.01. 3, the preparation of the floating-point LMS algorithm in Matlab, draw the output waveform equalizer, and with the training sequence comparison.)
- 2013-12-05 14:53:23下载
- 积分：1
-
read_ieee_vector_monthly
读ncdc风场数据，包括速度场和风应力旋度场(read wind data)
- 2012-01-09 15:08:10下载
- 积分：1
-
final
lagrange.m proram with matlab
- 2010-08-23 04:00:44下载
- 积分：1
-
EgressRouter
code of an egress router for a mail management system
- 2009-12-11 17:28:33下载
- 积分：1
-
互信息法求混沌序列的最优时延 Mutual_Information_upload
互信息法求混沌序列的最优时延，希望对大家有用。(mutual information for the optimal sequence delay, we hope that the right useful.)
- 2007-03-09 19:55:50下载
- 积分：1
-
kalman_basic
这个例子中，简单介绍了卡尔曼滤波器的原理，并给出具体的算法设计，解决工程问题。(a brif introduction is given for the kalman filter design. and the source codes are included for engineering)
- 2013-08-29 17:33:19下载
- 积分：1
-
Chapter3
北京航空航天出版社matlab从零到进阶的第三章程序(Beijing University of Aeronautics and Astronautics Press matlab from zero to advanced procedures in Chapter III)
- 2014-01-13 10:50:37下载
- 积分：1
-
entropy
this file can be used to calculate the entropy of english language.
- 2013-08-08 23:28:39下载
- 积分：1
-
svm-by-Steve-Gunn
This toolbox was designed as a teaching aid, which matlab is
particularly good for since source code is relatively legible and
simple to modify. However, it is still reasonably fast if used
with the supplied optimiser. However, if you really want to speed
things up you should consider compiling the matrix composition
routine for H into a mex function. Then again if you really want
to speed things up you probably shouldn t be using matlab
anyway... Get hold of a dedicated C program once you understand
the algorithm.
- 2011-06-05 16:45:29下载
- 积分：1
