-
sound-source_positioning
基于labview的声源定位,利用广义互相关法求声音信号到麦克风阵列的时间差,然后根据麦克风阵列的距离阵型求得声源的位置(Sound Source Localization Based labview, the use of generalized cross correlation method the sound signal to the time difference between the microphone array, and then formation determined according to the location of the sound source the microphone array )
- 2017-01-11 17:18:55下载
- 积分:1
-
一种基于LabView的环境监测与预警系统设计
说明: 本项目是以 LabVIEW 为开发平台的环境监控与预警系统,实现了对温度,烟雾和电压电流等信号的实时采集、记录、存储和回放等功能程序的模块化设计,从而达到环境监控的目的。(This project is an environmental monitoring and early warning system based on LabVIEW. It realizes the modular design of functions such as real-time acquisition, recording, storage and playback of signals such as temperature, smoke and voltage and current, thus achieving the purpose of environmental monitoring.)
- 2019-05-07 14:05:02下载
- 积分:1
-
labview温度计实验
labview温度计系列实验,数据采集与回放系统(LabVIEW thermometer series experiment Data acquisition and playback system)
- 2017-06-30 23:16:38下载
- 积分:1
-
serial_communication
本代码编制测距传感器的串口通讯接口VI;通过波形图表显示连续读取的测距-时间曲线,并将有效测量范围外的数据滤除。(This code compiles the serial communication interface VI of ranging sensor, displays the continuous read ranging-time curve through waveform chart, and filters out the data outside the effective measurement range.)
- 2019-01-03 19:53:29下载
- 积分:1
-
PPG
LabVIEW脉搏波采集程序,可以控制采集的开始和停止(Pulse acquisition of LabVIEW)
- 2013-07-18 09:49:30下载
- 积分:1
-
pid控制
用户通过数据采集卡采集到模拟数据,与预先设定的值进行比较,PID运算(Users collect analog data through data acquisition card, compare with pre-set values, and perform PID operation.)
- 2020-06-17 01:40:01下载
- 积分:1
-
虚拟示波器
说明: 简单虚拟示波器,能调节幅值,频率,相位和偏移量四种变量。(Simple virtual oscilloscope can adjust four variables: amplitude, frequency, phase and offset.)
- 2019-04-08 13:16:59下载
- 积分:1
-
USB_gonglvji
USB功率计读取,labview2014编写(USB power meter reads, labview2014 write)
- 2015-05-16 21:12:34下载
- 积分:1
-
Noise-detection
用Labview分析笔记本采集到的噪声信号频率计权声级(Using Labview analysis laptop to noise signal frequency meter right sound level)
- 2013-09-21 14:06:31下载
- 积分:1
-
UDP-simple-chat-program
LabView中UDP通讯,通过IP地址与端口号可以进行单机或局域网内多台计算机之间的信息通讯。(LabView UDP traffic by IP address and port number to the communication of information between multiple computers in stand-alone or LAN.)
- 2012-10-24 17:33:46下载
- 积分:1