-
real-time
说明: 根据倾角仪输出信号labview实时显示曲线图像的labview程序(Real-time display of curve image based on LabVIEW output signal of inclinometer)
- 2019-02-27 20:03:49下载
- 积分:1
-
8.3.2
小波去噪算法及传统去噪算法在LabVIEW中的比较(Comparison of wavelet denoising algorithm and traditional denoising algorithm in LabVIEW
)
- 2017-05-08 19:53:34下载
- 积分:1
-
moving-average
LABVIEW求数组的N个元素的滑动平均值(LABVIEW find moving average of N elements of the array)
- 2021-03-17 02:09:20下载
- 积分:1
-
labview-applet-reference
初学者自学labview小程序参考,包括5判断素数、报数问题、自功率谱处理、跑马灯、模拟汽车控制、登陆界面……各种学习小程序(Beginners learning labview applet reference, including five judgments primes, reported few problems, since the power spectrum processing, marquees, simulated vehicle control, landing a variety of learning applet interface ......)
- 2013-09-25 19:56:24下载
- 积分:1
-
daq
本文主要介绍了利用国产普通数据采集卡,基于美国 NI 公司提供的虚拟仪
器软件开发平台 LabVIEW 和实验室原有发动机硬件平台自行开发的一套气缸压
力采集模块和数据分析模块(This thesis primarily introduced software about cylinder pressure and crank
angle acquisition and data analysis module. It is designed by using a general data
acquisition board, which is based on Virtual Instrument LabVIEW offered by NI and
laboratory engine.
)
- 2013-05-23 20:34:34下载
- 积分:1
-
The-electrical-system-LabVIEW
LabVIEW心电检测系统,主要是滤波 信号采集 频谱分析 显示波形等(LabVIEW ECG detection system is mainly filtered signal acquisition spectrum analysis shows waveforms)
- 2013-08-29 17:34:25下载
- 积分:1
-
depict
编写软件为labview2011,功能为读取txt文件中的值,并绘制电平图,设置了双游标,可以自动准确计算出两游标X轴时间差值。txt的内容为上升沿或下降沿的时间信息,首位0代表下降沿,1代表上升沿。后面位的值乘16代表沿的绝对时间(program software is the labview2011, functions is to read txt file values , and draw level diagram, set up a dual cursors, you can automatically and accurately calculate the time difference between the two cursors X axis. txt contents of rising or falling time information, the first 0 represents falling, a representative of the rising edge. Followed by 16-bit value represents absolute time along)
- 2013-08-08 10:44:10下载
- 积分:1
-
Satellite-Labview-Visualization
利用LabVIEW的Active X模块以及STK的Connect
模块实现两种软件交互的方法,通过LabVIEW
的Active X功能连接STK,利用Connect模块中的指令驱动STK产生卫星的相关数据,最终将有关数据返回至Lab VIEW中并显示出来,实现了Lab VIEW与STK的无缝连接(Design of a Satellite Orbit Prediction Visualization Platform Based on Lab VIEW and STK
A method of designing a satellite orbit prediction visualization platform based on a hardware-in-loop
validated simulation system of small satellite is introduced. Satellite Tool Kit is an analysis software widely used in
simulating orbit system for satellite
,
but STK can’t accomplish the relevant function that acquired by the hardware-
in-loop validated simulation system mentioned. Based on this requirement
,
a method of using Active X technology in
Lab VIEW and STK/Connect module to interact the two kinds software is introduced. Through calling STK and u-
sing Connect module in STK to obtain the relevant data
,
finally all the datas in need within a window synchronously
can be displaied
,
which realized the connection between Lab VIEW and STK
,
also accomplished the relevant func-
tion and has a applied value.
)
- 2020-09-07 15:48:03下载
- 积分:1
-
MS9710C--2011
安立光谱仪MS9710C的Labview例程,可在labview2011,labview 8.5打开,其他版本未测试。(labview examples for Anritsu MS9710C)
- 2020-09-10 19:28:01下载
- 积分:1
-
stanford_research_830
Stanford Research 830 Acquire Measurement 用于锁相放大器的单个参数,多个参数,多点的测量(Stanford Research 830 Acquire Measurement for single parameter, multiple parameter, multi-point measurement for PLA)
- 2020-06-17 02:00:01下载
- 积分:1