-
Pisarenko
皮萨论科(Pisarenko)谐波分解法,求得含噪声信号中的谐波频率(Pisanoko (Pisarenko) harmonic decomposition method, obtained with the noise signal in the harmonic frequency)
- 2021-03-18 12:19:20下载
- 积分:1
-
MapMatching
Map matching is the process of assigning user s location to the nearest node one a network. Three algorithms of map matching, point to point, point to line and line to line are presented in this document.
- 2010-03-12 20:37:39下载
- 积分:1
-
exm09314_1
上传Matlab源代码程序,希望对下载的人有所帮助(Upload Matlab source code procedures in the hope that the right people download help)
- 2007-04-25 16:48:07下载
- 积分:1
-
DPFC
In this paper, we introduced a new series-shunt type FACTS controller called as distributed power flow controller to
improve and maintain the power quality of an electrical power system. This DPFC method is same as the UPFC used to
compensate the voltage sag and the current swell these are voltage based power quality problems. As compared to UPFC
the common dc link capacitor is removed and three individual single phase converters are used instead of a three phase
series converter. Series referral voltages, branch currents are used in this paper for designing control circuit. The evaluated
values are obtained by using MATLAB/SIMULINK.
- 2021-02-23 09:29:40下载
- 积分:1
-
orientation
车牌定位:对侯选区域加以判别,侯选区域的判定可以利用车牌区域固有的特征来进行(License Plate Location: identification of candidate regions to be, to determine candidate regions of license plate can be used to carry out the inherent characteristics of)
- 2011-01-05 19:58:19下载
- 积分:1
-
fir_l.m
FIR Low pass filter simulation using matlab
- 2011-08-20 01:24:14下载
- 积分:1
-
syn_sub_4f
synonmous substitution code
- 2011-09-07 08:07:24下载
- 积分:1
-
modeling-PV-MPPT
对光伏电板进行详细建模,在simulink里面搭建,并进行最大功率跟踪(modeling PV,MPPT)
- 2014-02-19 15:20:36下载
- 积分:1
-
PSNR
to calculate psnr for images by matlab
- 2015-03-16 04:01:55下载
- 积分:1
-
wgy
无功优化IEEE论文With the increased loading of existing power system, the problem of voltage stability
and voltage collapse has become a major concern in power system planning and operation. The
dependence of the system voltage profile on reactive power distribution forms the basis for reactive
power optimisation. The technique attempts to utilises fully the reactive power sources in the
system to improve the voltage profile and also to meet the reactive power requirements at the
AC–DC terminals to facilitate the smooth operation of DC links. The method involves successive
solution of steady-state power flows and optimisation of reactive power control variables with
unified power flow controllers using linear programming technique. The proposed method has(With the increased loading of existing power system, the problem of voltage stability
and voltage collapse has become a major concern in power system planning and operation. The
dependence of the system voltage profile on reactive power distribution forms the basis for reactive
power optimisation. The technique attempts to utilises fully the reactive power sources in the
system to improve the voltage profile and also to meet the reactive power requirements at the
AC–DC terminals to facilitate the smooth operation of DC links. The method involves successive
solution of steady-state power flows and optimisation of reactive power control variables with
unified power flow controllers using linear programming technique. The proposed method has
been tested on a real life equivalent 96-bus AC and a two terminal DC system.)
- 2010-01-21 11:31:29下载
- 积分:1