登录
首页 » matlab » dfig

dfig

于 2014-05-17 发布 文件大小:8KB
0 155
下载积分: 1 下载次数: 102

代码说明:

  MATLAB/SIMULINK下的DFIG纯公式模型。(DFIG formula model in MATLAB/SIMULINK.)

文件列表:

dfig.mdl,42093,2014-05-17

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • MIMOMRC
    MIMO MRC system - maximum ratio combining(MIMO MRC system- maximum ratio combining)
    2009-05-29 15:14:47下载
    积分:1
  • Untitled
    差分格式编码,用matlab仿真,结果可以仿出来,有需要的就下吧(Differential encoding format, with the matlab simulation, results can fake it, need it for the next)
    2011-05-04 09:07:05下载
    积分:1
  • coding
    1 transmitter 1 receiver rician channel gui
    2015-02-11 18:47:40下载
    积分:1
  • binary3
    make binary from image part3
    2012-01-19 13:45:12下载
    积分:1
  • mark
    这是学生成绩划分的matlab程序,简单易懂(This is the division of student achievement matlab program, easy to understand)
    2011-08-01 15:54:39下载
    积分:1
  • plateloss
    finite difference scheme for the thin plate equation with loss
    2014-11-11 08:52:15下载
    积分:1
  • kd
    说明:  根据前人研究成果可以证明,煤镜质组反射率各向异性对煤田构造特征具有指示意义,镜质组最小反射率可以指示构造主应力方向。然而,在实际测量中,如何得到真正的镜质组最大、最小反射率及其方位是其中的关键环节。利用现有的岩石有限应变椭球拟合方法进行镜质组反射率椭球体拟合不失为一种行之有效的方法,可以由此确定镜质组最大、最小、中间反射率及其三维空间方位。 将之前拟合得到的反射率椭圆看作岩石有限应变椭圆即二维应变,其由之前的统计方法测定得到,三个截面的数据对于拟合唯一应变椭球来说是过多的,因此不可避免出现误差,导致三个截面应变椭圆不通过同一个椭球的情况。为了从三个截面数据得到唯一的应变椭球,需要对得到的数据进行相容性调整。采用Oertel的方法,从每一测量参数在不同截面中的值是正态分布这一假定出发,利用加权最小二乘法进行误差调整。(According to results of previous studies may prove vitrinite reflectance anisotropy on structural characteristics have implications for coal, vitrinite reflectance may indicate tectonic minimum principal stress directions. However, in actual measurement, how to get real vitrinite maximum, minimum reflectivity and its orientation is the key link. Conduct vitrinite reflectance ellipsoid fitting regarded as a proven method using existing rock finite strain ellipsoid fitting method can thus determine vitrinite maximum, minimum, intermediate reflectance and dimensional spatial orientation . Before fitting the reflectance of finite strain ellipse oval rock that is seen as a two-dimensional strain, as determined by statistical methods which have been before the data fit only for the three sections of the strain ellipsoid is excessive, and therefore can not to avoid errors, resulting in three elliptical cross-section does not pass through the same strain ellipsoid situation. In order to obtai)
    2014-11-12 11:06:13下载
    积分:1
  • NLPCArec
    the function which finds fault location
    2014-12-01 06:37:02下载
    积分:1
  • main_Noncoherent_dec
    实现扩频里随机信号和伪码序列的产生,以及关于生成扩频序列的MATLAB程序,并用载波信号实现2PSK调制,在接收端用非相干积分实现捕获以及虚警概率的计算(Spread spectrum signal generated in the realization and pseudo random code sequence, and generate MATLAB program about spreading sequences and achieve 2PSK modulated carrier signal used to calculate the receiving end with a non-coherent integration to achieve capture and probability of false alarm)
    2021-05-08 17:58:35下载
    积分:1
  • 新建文件夹
    说明:  对一个简单地系统,设计pid控制器使其控制它的稳定(For a simple system, a PID controller is designed to control its stability.)
    2020-06-25 01:20:02下载
    积分:1
  • 696518资源总数
  • 104444会员总数
  • 15今日下载