登录
首页 » matlab » matlab

matlab

于 2013-01-31 发布 文件大小:335KB
0 189
下载积分: 1 下载次数: 21

代码说明:

  电磁场程序设计 ——采用有限差分法计算屏蔽微带传输线的电位及其电容(Electromagnetic field programming- using the finite difference method shielded microstrip transmission line potential and its capacitance)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • general
    general training of neural network
    2009-11-14 01:42:54下载
    积分:1
  • matlabECG02
    说明:  心电信号仿真数学模型建立,包含心电图波形的检测(ECG simulation of mathematical model-building, including the detection of ECG waveforms)
    2009-08-18 09:41:53下载
    积分:1
  • MRS_Signal_1
    MRS Water Suppression.
    2014-08-31 23:56:29下载
    积分:1
  • 项目4
    说明:  任务:设计一个4×2.5Gbit/s 长距离光纤传输系统,并利用OptiSystem 仿真验证。 要求: 1.采用波分复用技术,波长设置以100GHz 为间隔,频率分别为193.1THz、193.2THz、193.3THz、193.4THz,每个波长传输速率为2.5Gbit/s(NRZ),传输距离为300km。采用常规光纤,光纤损耗系数为0.25dB/km。 2.单通道光发送机最大输出功率为0dBm,光接收机的接收光功率不低于-26dBm,过载点为-10dBm。 3.可以采用EDFA 作为线路放大器,其中EDFA 的输入功率限制在-18~2dBm,最大输出功率20dBm,增益范围为13~25dB,噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify. Requirement: 1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km. 2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm. 3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)
    2019-05-13 09:39:41下载
    积分:1
  • psnrofFG
    函数dB=PSNR(F,G),返回图像F相对于图像G的信噪比峰值.用于全息图后期处理中的参考.测试通过(Based of the formular dB=PSNR(F,G),it returns peak signal-to-noise ratio (dB) of image F with respect to G.)
    2011-10-25 15:54:48下载
    积分:1
  • QPSK1
    说明:  该程序实现QPSK的调制与解调,并计算误码率(The program realization QPSK modulation and demodulation, and calculate the error rate)
    2010-04-14 22:45:12下载
    积分:1
  • apes
    APES谱估计方法的matlab源代码,已经通过验证(APES spectral estimation methods matlab source code has been validated)
    2009-07-08 16:01:34下载
    积分:1
  • matlab-GUI
    matlab GUI 多界面数据传递实例(matlab gui )
    2015-03-13 10:20:40下载
    积分:1
  • Bitplanemap
    说明:  灰度图像的位面图程序 matlab环境下写的 希望能有帮助(Gray image Bit plane map program, hopes to help you)
    2010-04-09 17:16:38下载
    积分:1
  • fdtd_method
    高本庆老师编写的时域有限差分法的学习教程,推荐(the high-prepared teachers FDTD method of study guides, recommended)
    2006-12-04 12:06:05下载
    积分:1
  • 696518资源总数
  • 106208会员总数
  • 21今日下载