登录
首页 » matlab » Automatic-Region-DEtection-and-Conversion

Automatic-Region-DEtection-and-Conversion

于 2013-01-01 发布 文件大小:15135KB
0 220
下载积分: 1 下载次数: 42

代码说明:

  Automatic Image Segmentation by Integrating Color-Edge Extraction and Seeded Region Growing

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • mirregularity
    this mfile is riten in matlab and is related to mirtoolbox
    2010-07-29 05:59:50下载
    积分:1
  • f8
    说明:  利用lms算法实现自适应滤波器的matlab仿真(The use of LMS adaptive filter algorithm matlab simulation)
    2008-05-24 03:50:14下载
    积分:1
  • SENS-01_PLC-doc1.3
    Sends 电力线载波模块文档,对初学电力线载波技术的人有很大帮助(PLC document for the designer)
    2016-03-08 16:49:48下载
    积分:1
  • 互相关
    本程序主要进行两个时间序列的互相关计算。可用于信号降噪分析。(This program mainly carries out the cross correlation calculation of two time series. It can be used for signal noise reduction analysis.)
    2018-01-30 10:05:26下载
    积分:1
  • 8QAM
    说明:  利用matlab仿真软件,实现8QAM调制。在实现时采用正交调幅的方式,某星座点在I坐标上的投影去调制同相载波的幅度,在Q坐标上的投影去调制正交载波的幅度,然后将2个调幅信号相加就是所需的调相信号。(Use of matlab simulation software to achieve 8QAM modulation. In achieving the adoption of quadrature amplitude modulation means of a constellation in the I coordinates of the projection to the modulation of the amplitude-phase carrier, in the Q coordinates of the projection to the range of carrier orthogonal modulation, and then the sum of two AM signals is the required phase modulation signal.)
    2008-11-05 10:39:42下载
    积分:1
  • RobotiCad
    采用matlab编写的对固定基座机器人动力学分析的程序,在simulink环境中运行。(Matlab prepared using a fixed base robot dynamic analysis procedures, in simulink environment.)
    2009-06-25 08:02:35下载
    积分:1
  • ThinPlateSpline_MatlabCode
    薄板样条图像变换方法,MATLAB程序,根据控制点变化平滑地变形图像,experiment.m为例子(Thin plate spline image transformation method, MATLAB program, based on the control points change smoothly deformed image, experiment.m for example)
    2014-09-28 20:29:02下载
    积分:1
  • sloding
    本书从MATLAB仿真角度系统地介绍了滑模变结构控制的基本理论、基本方法和应用技术,是作者多年来从事控制系统教学和科研工作的结晶,同时融入了国内外同行近年来所取得的新成果。 全书共分10章,包括滑模变结构控制发展综述、连续时间系统滑模控制、离散时间系统滑模控制、模糊滑模控制、神经滑模控制、基于反演设计的滑模控制、动态滑模控制、基于干扰估计的滑模控制、Terminal滑模控制以及几种新型滑模控制。 每种控制方法都通过MATLAB仿真程序进行了仿真分析。 ( Book from the MATLAB simulation Jiaodu a systematic introduction to the basic sliding mode control theory, the basic method and application of technology, is the author control systems for many years engaged in teaching and research work of the crystal, and into the domestic and foreign counterparts in recent years made new results. The book is divided into 10 chapters, including the development of sliding mode control synthesis of continuous-time sliding mode control systems, discrete-time sliding mode control systems, fuzzy sliding mode control, neural sliding mode control, sliding mode control design based on inverse dynamic slip mode control, sliding mode control based on interference estimation, Terminal sliding mode control, and several new types of sliding mode control. Each control methods are carried out by MATLAB simulation program simulation.)
    2012-01-18 20:36:59下载
    积分:1
  • EasyGUI_v1_0
    主要作为初学者对matlab界面设计,非常经典(主要作为初学者对matlab界面设计)
    2009-03-17 16:53:21下载
    积分:1
  • blurred
    this file describes and run the blurring of a picture.
    2011-01-10 19:52:03下载
    积分:1
  • 696518资源总数
  • 106245会员总数
  • 18今日下载