-
RecursiveLeastSquare
this is matlab code for estimating the static linear system with Recursive Least Squre that is written by matlab 7.0.
Here we want to estimate the below function:
1 - u^2 + 2*u^3 +u^5 +3*u^7
these are 2 files : without noise and with noise
finally,there are plots for showing results.
- 2010-08-26 23:14:16下载
- 积分：1
-
exm09714_1
上传Matlab源代码程序，希望对下载的人有所帮助(Upload Matlab source code procedures in the hope that the right people download help)
- 2007-04-25 16:46:56下载
- 积分：1
-
inpaint
the code for image inpainting algorithm
- 2013-03-03 15:03:36下载
- 积分：1
-
Elfouhaily
绘制Elfouhaily海浪谱，对于研究GNSS-R反演海面风速的很有帮助(Drawing the Elfouhaily wave spectrum is very helpful in studying GNSS-R inversion of sea surface wind speed.)
- 2021-04-13 11:48:56下载
- 积分：1
-
pmsm
几篇很有参考价值的关于永磁同步电机控制的matlab仿真论文，依据此可以搭建自己的仿真框图(A few worthy of permanent magnet synchronous motor control on the matlab simulation papers, according to this you can build your own simulation block diagram)
- 2010-09-15 16:22:09下载
- 积分：1
-
RCS-Radar_Systems_Analysis_and_Design_Using_MATLAB
《Radar Systems Analysis and Design Using MATLAB》中RCS的源程序(matlab program of RCS in《Radar Systems Analysis and Design Using MATLAB》
)
- 2021-04-04 21:59:04下载
- 积分：1
-
short
说明： Matlab下生成最短路径的程序。首先在m脚本文件canshuo.m中输入节点个数和路径权重，在命令窗口中输入canshu，用s=12,e=10的格式输入要求的起止点，再输入main即可得到两点之间的路径和长度。(This is the codes for Matlab to generate the shortest way.)
- 2009-08-01 11:03:34下载
- 积分：1
-
FAGD
说明： 这是一个用matlab仿真的联合对焦化盲源分离FAGD算法(This is a joint simulation with matlab blind source separation of coking FAGD algorithm)
- 2011-03-22 22:49:00下载
- 积分：1
-
222
本代码使用matlab实现理想高通滤波增强图像(Matlab to achieve ideal high-pass filtering to enhance the image)
- 2014-10-16 14:30:14下载
- 积分：1
-
base
1.分别在两个图中画出δ(n)和δ(n-2)，其中-10≤n≤10，画出U（n）其中-10≤n≤10。
2.分别在两个图中画出x1(n)=cos(2π×20×0.01×n)，0≤n≤10和x2(n)=(0.8)n，1≤n≤6。
3.由上一题，计算y(n)=x1(n)+x2(n)，并画图。(1. Draw the figure at two δ (n) and δ (n-2), where-10 ≤ n ≤ 10, draw the U (n) where-10 ≤ n ≤ 10. 2. Respectively in the two Draw the figure x1 (n) = cos (2π × 20 × 0.01 × n), 0 ≤ n ≤ 10 and x2 (n) = (0.8) n, 1 ≤ n ≤ 6. 3. from the previous question, calculate y (n) = x1 (n)+ x2 (n), and drawing.)
- 2010-11-26 16:34:06下载
- 积分：1
