-
gui_filter
Design of Filters using GUI (The code provides the user friendly GUI usage in filter design)
- 2009-09-21 19:24:43下载
- 积分：1
-
resp
从混有呼吸噪音的信号中，提取呼吸信号，完成去除呼吸信号的功能(Mixed with noise from the respiratory signal, respiratory signal extraction, complete removal of the function of respiratory signal)
- 2010-12-03 11:28:18下载
- 积分：1
-
Levelset
Chunming Li 老师的一种新的水平集图像处理方法，主要利用一种新的变分公式(Level set method image processing,A New Variational Formulation)
- 2009-12-18 13:07:56下载
- 积分：1
-
myVoice
说明： 用matlab将hanning窗、hamming窗、Blackman窗画在同一个图中。语音分帧，加窗，短时能量，短时过零率，端点检测(Using matlab to hanning window、hamming window and Blackman window draw in the same graph.Voice sub-frame, add windows, short-term energy, short-term zero-crossing rate, endpoint detection)
- 2010-03-22 15:29:34下载
- 积分：1
-
IO
说明： 控制安捷伦矢量信号源，在本地计算机上产生一个信号然后传入信号源，本代码含若干练习性的源代码，结合自己大量的调试经验，在signal1.m中对初学者甚至经常使用的用户极易犯得错误进行了详细标注，(Matlab generate data in the waveform file, downloaded to the Agilent signal sources. By reading it, you will get a lot.)
- 2021-01-26 22:38:41下载
- 积分：1
-
musicclock
音乐闹钟不但定时播放音乐而且有好的界面设计(the musicclock is used to remind of you the important thing and it has a good appearance.)
- 2011-06-17 17:42:29下载
- 积分：1
-
yiweirechuandao
一维热传导程序程序，很简单，完全可以套用的。是通用方法(One-dimensional heat conduction)
- 2011-12-08 21:39:52下载
- 积分：1
-
FFT_Model
resistive and inductive load. simulation also demonstrate the role of free wheeling diode. Single phase pulse generator was developed to generate the pulses at required firing angle.
- 2014-02-13 10:53:14下载
- 积分：1
-
对于小位移和桥梁变形的测量
说明： 对于小位移和桥梁变形的测量，一种很好的算法，对研究匹配也具有参考价值(For the measurement of small displacement and bridge deformation, a very good algorithm, also has reference value for research matching)
- 2020-06-23 02:40:01下载
- 积分：1
-
re1
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:51:25下载
- 积分：1
