-
Simulation
HARQ_simulations_convolutional code
- 2010-11-21 17:13:15下载
- 积分：1
-
matport
atport - Matlab接口模块
Matport是NTPort Library的MatLab接口模块。借助Matport，你可以在Matlab中直接访问PC的I/O端口。(atport- Matlab interface module Matport is NTPort Library of MatLab interface module. With Matport, you can directly access the PC in Matlab of the I/O port.)
- 2009-01-04 21:01:12下载
- 积分：1
-
fenlei
病虫害分类用,用来进行病害虫分类的MATLAB程序(Pest and disease classification used, the classification used for pest MATLAB program)
- 2010-09-11 15:25:13下载
- 积分：1
-
untitled1
光伏并网逆变器的仿真系统的S函数,能实现其的模拟仿真(PV grid-connected inverter simulation system S-function)
- 2013-10-13 15:51:56下载
- 积分：1
-
MYPCA2
利用pca计算出两个统计量，通过对统计量的大小比较以判定故障是否发生。(Pca is calculated using two statistics, by comparing the size of the statistic to determine whether the fault occurs.)
- 2020-12-01 23:09:26下载
- 积分：1
-
classifier
Classifier in matlab
- 2010-07-22 10:37:27下载
- 积分：1
-
exam3_1
本程序为《结构分析的有限元法与Matlab程序设计》第三章的第一个算例，采用平面梁单元计算平面刚架的变形和内力，已经过修改。(This program is "structural analysis of the finite element method and Matlab Programming" chapter of the first example, the use of plane beam element of plane frame deformation and internal forces, which have been modified.)
- 2011-02-10 02:44:48下载
- 积分：1
-
DSP_Homework_matlab_code
说明： 东南大学 信息学院 数字信号处理作业代码(DSP homework of Southeast University )
- 2011-02-28 16:00:22下载
- 积分：1
-
LAB
从均匀PCM方法入手，产生一振幅为1和频率ω=1的正弦信号，分别用8电平和16电平进行量化，在同一坐标轴上绘出原信号和以量化信号，并比较这两种情况下的信号/量化噪声比(Starting from the uniform PCM method to produce a 1 amplitude and frequency ω = 1 of the sinusoidal signal, respectively, with 8 levels and 16 levels were quantified in the same plot of the original signal and the axes to quantify the signals, and to compare these two cases, the signal/quantization noise ratio)
- 2011-04-27 17:31:51下载
- 积分：1
-
666
求零点、极点和增益，这是一些已经调好的实例，还有运行后的结果。(For zero, poles and gain, this is some have adjustable good examples, and after the operation result.
)
- 2011-05-04 22:46:14下载
- 积分：1
