-
pso3wei
对多元函数动态描述pso算法，可以根据此代码，只要稍微改动，就可以用于其他程序（matlab7.0以上版本）(Dynamic description of multi-function pso algorithm, based on this code, as long as a slight change, it can be used for other procedures (matlab7.0 above))
- 2009-05-29 09:56:14下载
- 积分：1
-
fastica
说明： 盲分离 独立算法估计，实用.大家可以分享(blind serparation)
- 2010-04-03 15:47:58下载
- 积分：1
-
OFDM_AWGN
说明： OFDM在AWGN信道下的仿真，用MATLAB实现，一共有6个程序。(OFDM AWGN under the simulation, using MATLAB, a total of six procedures.)
- 2006-04-12 21:01:50下载
- 积分：1
-
Multi-Wavelet111111
多小波分析工具箱，请大家分享，给与反馈，谢谢大家(Multiwavelet Analysis Toolbox, please share with you, give feedback, thank you)
- 2007-04-11 18:42:16下载
- 积分：1
-
queue
排队买饭程序：利用队列实现，可以有好朋友一起排队。(Queuing to buy food program: the use of queues to achieve, you can have friends lined up together.)
- 2014-01-11 21:28:30下载
- 积分：1
-
harq1
harq in lte for channel coding in matlab to correct error in 4g
- 2019-06-10 03:09:37下载
- 积分：1
-
潮流计算程序1
说明： 潮流计算是电力学名词，指在给定电力系统网络拓扑、元件参数和发电、负荷参量条件下，计算有功功率、无功功率及电压在电力网中的分布。潮流计算是根据给定的电网结构、参数和发电机、负荷等元件的运行条件，确定电力系统各部分稳态运行状态参数的计算。通常给定的运行条件有系统中各电源和负荷点的功率、枢纽点电压、平衡点的电压和相位角。待求的运行状态参量包括电网各母线节点的电压幅值和相角，以及各支路的功率分布、网络的功率损耗等。(Power flow calculation is a term of power science. It refers to the calculation of the distribution of active power, reactive power and voltage in power network under given network topology, component parameters and generation and load parameters. Power flow calculation is based on the given grid structure, parameters and operation conditions of generator, load and other components to determine the steady-state operation parameters of each part of the power system. Usually, the given operating conditions include the power of each power source and load point, junction voltage, balance point voltage and phase angle. The parameters to be determined include the voltage amplitude and phase angle of each bus node, the power distribution of each branch and the power loss of the network.)
- 2020-06-23 10:00:01下载
- 积分：1
-
grd_test
xwch_test.m是主测试文件；biaoji.mat存放滤波器系数；xiangweicha.m用FFT计算相位差。
仿真框架为：
1.标记信号和双音信号续接作为发送信号；
2.对双音中一个频率分量的相位做偏移，再经过一个低通滤波器（引入线性相位，模拟收发不能同步测量现象）后，作为收到的信号；
3.用一个检测信号对收发信号进行相关运算；
4.画出收发信号以及相关处理后的信号。找出相关信号的那个尖点，从而推算出收发双音信号0相位点；
5. 输入0相位点位置，计算相对相位差。(xwch_test.m is the main test file biaoji.mat store filter coefficients xiangweicha.m calculated using FFT phase difference. Simulation framework: 1. Mark signals and then as a two-tone signal continued to send signals 2. On a two-tone frequency components of the phase shift to do, and then through a low pass filter (the introduction of linear phase, simulation can not simultaneously send and receive measuring the phenomenon), the as received signal 3. using a detection signal of the transceiver signal correlation operation 4. draw send and receive signals and related processed signal. Correlated signal of the cusp, which calculate the two-tone signal transceiver 0 phase point 5. Enter 0 phase point position, calculate the relative phase difference.)
- 2010-06-12 17:31:00下载
- 积分：1
-
thermo
Simulation modèle thermodynamique sur MATLAB
- 2013-12-31 00:30:03下载
- 积分：1
-
gpso4.2-opt
基于遗传微粒群算法，对旅行商问题求解，采用2-opt进行局部搜索。GPSO4tsp(Genetic particle swarm algorithm for solving the traveling salesman problem, using 2-opt local search. GPSO4tsp)
- 2013-12-03 10:06:21下载
- 积分：1
