登录
首页 » Matlab » 推荐下载DOA估计常用算法调试工具

推荐下载DOA估计常用算法调试工具

于 2023-09-09 发布 文件大小:7.86 kB
0 270
下载积分: 2 下载次数: 1

代码说明:

应用小区域方差对比,程序简单,是路径规划的实用方法,采用加权网络中节点强度和权重都是幂率分布的模型,利用自然梯度算法,一种流形学习算法(很好用),使用拉亚普诺夫指数的公式。

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • netcode_opt
    its a code for mobile communication markov models
    2010-10-02 18:32:22下载
    积分:1
  • ImageCompressed
    利用霍夫曼编码算法对数字图像进行压缩及解压缩处理,解压出来的图像与源图像几乎完全一致,峰值信噪比为无穷大(The use of Huffman coding algorithm for digital image compression and decompression processing, extracting images from the source image is almost exactly the same infinite PSNR)
    2021-05-14 17:30:02下载
    积分:1
  • tiqu
    说明:  提取信号七个基于瞬时信息的特征:零中心归一化瞬时幅度功率谱密度的最大值,零中心归一化瞬时幅度绝对值的标准偏差,零中心非弱信号段瞬时相位非线性分量绝对值标准偏差,零中心非弱信号段瞬时相位非线性分量标准偏差,零中心归一化的非弱信号段瞬时频率绝对值的标准偏差,一个信号段的归一化瞬时频率功率谱密度的最大值,根据信号 QPSK 和16QAM在 XI 轴投影的不同表现,提出特征参数。(Extraction based on instantaneous information signal of seven characteristics: zero center normalized instantaneous amplitude of the maximum power spectral density, zero-center normalized standard deviation of the instantaneous rate of absolute zero center section of non-weak signal instantaneous phase nonlinear component absolute value of standard deviation, non-zero center section of the weak signal non-linear component of the standard deviation of the instantaneous phase, zero-center non-normalized absolute value of the weak signal section of the standard deviation of the instantaneous frequency of a signal segment of the normalized power spectral density of instantaneous frequency maximum, according to the signal QPSK and 16QAM in the XI-axis projection of the different performance of the proposed characteristic parameters.)
    2010-05-04 16:32:23下载
    积分:1
  • gui
    运用matlab软件,进行回归运算,方便快捷(Use matlab software, regression calculation, convenient)
    2013-09-14 10:17:53下载
    积分:1
  • Matlab
    《Matlab遗传算法工具箱及应用》源码(The Matlab genetic algorithm toolbox and application source code )
    2015-01-22 15:07:53下载
    积分:1
  • rainflow-(2)
    雨流算法的matlab程序,我运行过了,可以使用-(The rainflow algorithm matlab program, I run, you can use the-)
    2012-11-14 19:57:41下载
    积分:1
  • carriermodulation
    This is used for carrier modulation
    2014-02-08 18:42:40下载
    积分:1
  • firsubband_g
    this is the active noise developed by running an active sysetem
    2011-08-06 20:47:22下载
    积分:1
  • Yagi_Antenna_Matlab
    This is the Matlab code for Yagi antenna design , very useful .
    2013-08-15 13:36:58下载
    积分:1
  • ldpc
    ldpc编译码程序,本文档是由matlab编写(运行时,请将alist_2_sparse的下划线去掉:alist2sparse)(ldpc codec program (matlab source))
    2011-11-15 22:05:07下载
    积分:1
  • 696518资源总数
  • 106215会员总数
  • 5今日下载