-
procedure for microcontroller development process, 1
此程序为 单片机开发过程中，1―wire总线方式数字温度传感器的控制显示程序。供参考-procedure for microcontroller development process, 1-wire bus mode digital temperature sensor control display program. For reference
- 2022-10-28 02:00:03下载
- 积分：1
-
该书是单片机入门的一本好书，值得大家一看共同学习
该书是单片机入门的一本好书，值得大家一看共同学习-The book is a single-chip entry of a good book, it is worth one U.S. study of common look
- 2023-06-22 02:45:03下载
- 积分：1
-
MSP430 microcontroller+ DS1302 LCD Clock+1602 portfolio program operating enviro...
MSP430单片机 + DS1302时钟+1602液晶 组合程序，运行环境为IAR-EW 3.42-MSP430 microcontroller+ DS1302 LCD Clock+1602 portfolio program operating environment for the IAR-EW 3.42
- 2022-09-10 08:45:03下载
- 积分：1
-
用于两单片机利用串口通信。有完整的原理图、仿真、程序。...
用于两单片机利用串口通信。有完整的原理图、仿真、程序。-For the use of two single-chip serial communication. A complete schematic, simulation, process.
- 2023-05-28 01:30:03下载
- 积分：1
-
c51单片机与ＰＣ间的串口 通信驱动程序
c51单片机与ＰＣ间的串口 通信驱动程序-C51 MCU and PC serial communication between the driver
- 2022-07-19 12:30:04下载
- 积分：1
-
基于tw2835的的相关源代码程序，由一款51单片机来控制
基于tw2835的的相关源代码程序，由一款51单片机来控制-Tw2835-based source code of the relevant procedures, by a single-chip microcomputer 51 to control the
- 2022-02-20 15:39:02下载
- 积分：1
-
51单片机控制USB的源代码,不带DMA控制功能.
51单片机控制USB的源代码,不带DMA控制功能.-51 USB MCU control of the source code, non- DMA control functions.
- 2022-03-03 05:10:04下载
- 积分：1
-
MCS
MCS-51单片机有5个中断源，其中两个是由-INT0、-INT1引脚输入的外部中断源；另外三个是内部中断源即由T0、T1的溢出引起中断和串行口发送完一个字节或接收到一个字节数据引起中断。触发外部中断有两种方式，即下降沿引起中断或低电平引起中断。当编程TCON中的ITi（i=0、1）为1时，则引起触发的方式为边沿触发方式，反之(ITi=0)为低电平触发方式。每个中断源的中断请求能否得到响应要受两级“开关”的控制，即一个总“开关”-MCS-51 single-chip has five interrupt sources, two of which are by-INT0,-INT1 pin input external interrupt source the other three internal interrupt sources from the T0, T1 overflow caused by the disruption and serial port sending or receiving end of a byte to a byte of data caused by interruption. Triggered external interrupt has two modes, namely, falling edge or low-level disruption caused disruption caused. When programming TCON in ITi (i = 0,1) for the 1:00 has been the subject of a way to trigger the way to the edge of the trigger, on the contrary (ITi = 0) for low-level trigger mode. Each interrupt source interrupt request can be subject to levels in response to
- 2023-07-06 00:00:03下载
- 积分：1
-
秒表程序
秒表程序-Stopwatch program
- 2022-01-27 23:08:22下载
- 积分：1
-
Using L298 as the drive to control two
用L298作为驱动器，控制两相混合式步进电机。
按键从上至下分别为减速，加速，正转，反转，停止。
具体参数还没有设定过。速度有些慢，加速按2下有效，然后就不能再快了。
转速输出是按照最小系统版的数码管写的。电路图里太麻烦就没画了。-Using L298 as the drive to control two-phase hybrid stepping motor. Buttons from top to bottom respectively, deceleration, acceleration, are being transferred, reverse, stop. Specific parameters have not yet been set. Some of the slow speed, speed up by 2, effectively, and then can not be faster. Speed output is in accordance with the minimum system version of the digital tube wrote. Circuit where not too much trouble drew.
- 2022-04-23 14:56:47下载
- 积分：1
