-
51 single
51单片机控制TC35I无线通信模块的完整Keil C程序，还包含GB2312与Unicode转换，国标汉字、ASC字符显示，串口通信，液晶模块控制等程序。-51 single-chip wireless communication module TC35i control the integrity of Keil C procedures, also includes GB2312 and Unicode conversion, GB characters, ASC characters display, serial communications, LCD module control procedures.
- 2022-08-03 22:49:25下载
- 积分：1
-
msp430入门所需的资料全在里面的，是PDF版！
msp430入门所需的资料全在里面的，是PDF版！-MSP430 entry required that all information furnished on the inside is PDF version!
- 2022-02-15 00:35:25下载
- 积分：1
-
单片机实现以太网接口 有详细的原理图和代码
单片机实现以太网接口 有详细的原理图和代码-Realize single-chip Ethernet interface has detailed schematics and code
- 2022-05-19 04:40:16下载
- 积分：1
-
这是一个1602液晶的显示程序，基于51单片机，已实验成功
这是一个1602液晶的显示程序，基于51单片机，已实验成功-This is a 1602 LCD display procedures, based on 51 single-chip, has conducted successful experiments in
- 2022-03-03 23:34:22下载
- 积分：1
-
c8051f020 pca 的简单应用程序
c8051f020 pca 的简单应用程序-c8051f020 pca simple application
- 2022-03-14 13:27:40下载
- 积分：1
-
异步串行通信接受单元的设计源程序
异步串行通信接受单元的设计源程序...
异步串行通信接受单元的设计源程序
异步串行通信接受单元的设计源程序-Asynchronous serial communication module designed to accept source asynchronous serial communication module designed to accept source code
- 2022-05-06 19:20:30下载
- 积分：1
-
记忆更深的理解
深入了解内存-Deeper understanding of memory
- 2022-03-09 13:54:53下载
- 积分：1
-
基于AVR单片机的USB驱动源程序.内有多个例子供参考,
基于AVR单片机的USB驱动源程序.内有多个例子供参考,-Based on the AVR MCU USB driver source code. There are a number of examples for reference,
- 2022-11-14 15:00:03下载
- 积分：1
-
avr入门用的 有protus仿真图
avr入门用的 有protus仿真图
-avr entry has protus simulation used in Figure
- 2023-03-26 18:30:05下载
- 积分：1
-
keilc+ proteus light parallel port design of experiments requirements: master th...
keilc + proteus
并行口设计指示灯实验
要求：掌握80C51单片机输入输出接口使用方法
学会开关量输入输出控制的接口技术及编程方法
实验题目：8个发光二极管D1~D8分别接在单片机P1.0-P1.7端口上，一个开关接在P3.0上。要求输出端口输出 “0”时，发光二极管亮。开关闭合时，开始按P1.0-P1.1-...-P1.7的顺序依次点亮LED，再按 P1.7-P1.6 -...-P1.0的顺序点亮LED，重复循环。开关断开时，立刻停止点亮指示灯。-keilc+ proteus light parallel port design of experiments requirements: master the 80C51 microcontroller input and output interfaces Society of switch to use the amount of input and output control interface technology and programming methods Experimental subjects: eight light-emitting diodes D1 ~ D8, respectively connected to the MCU P1.0-P1 .7 port on a switch connected to the P3.0 on. Requested output port output " 0" , the light-emitting diode light. Is closed, to embark on the P1.0-P1.1-...- P1.7 in the order light LED, and then P1.7-P1.6-...- P1.0 order light LED Repeat cycle. Switch off when the stop light indicator.
- 2022-11-16 18:10:03下载
- 积分：1
