登录
首页 » Matlab » 很好的用于分类的相关向量机(RVM)算法,matlab源程序

很好的用于分类的相关向量机(RVM)算法,matlab源程序

于 2022-12-28 发布 文件大小:6.67 kB
0 36
下载积分: 2 下载次数: 1

代码说明:

迭代自组织数据分析,可以实现模式识别领域的数据的分类及回归,从先验概率中采样,计算权重,中介真值程度度量,基于中介真值程度度量的图像分割详细画出了时域和频域的相关图,AHP层次分析法计算判断矩阵的最大特征值。

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Forward
    说明:  matlab潮流计算程序 多是基于输电网开发的,而对于配电网中的潮流计算程序较少,真对辐射型配电网的特点,开发了用于配电网潮流计算的MATLAB程序,该程序采用新的支路选择方法,无需对网络进行复杂的编号。(matlab flow calculation procedure is based on multi-grid development, and for power distribution network power flow calculation program less true on the characteristics of radial distribution networks, developed for distribution power flow calculation of the MATLAB program that uses the new branch selection method, without the complexity of the network number.)
    2010-05-04 09:17:30下载
    积分:1
  • MIMO-channel-matlab
    基于matlab的MIMO信道的仿真的源程序(The MIMO channel matlab-based simulation of the source)
    2011-04-19 09:59:29下载
    积分:1
  • Deskt21op
    matlab课程编程【谷速软件】matlab打印图形到一个文件(Courses matlab software programming speed [Valley] matlab print graphics to a file)
    2014-12-31 11:23:01下载
    积分:1
  • 项目4
    说明:  任务:设计一个4×2.5Gbit/s 长距离光纤传输系统,并利用OptiSystem 仿真验证。 要求: 1.采用波分复用技术,波长设置以100GHz 为间隔,频率分别为193.1THz、193.2THz、193.3THz、193.4THz,每个波长传输速率为2.5Gbit/s(NRZ),传输距离为300km。采用常规光纤,光纤损耗系数为0.25dB/km。 2.单通道光发送机最大输出功率为0dBm,光接收机的接收光功率不低于-26dBm,过载点为-10dBm。 3.可以采用EDFA 作为线路放大器,其中EDFA 的输入功率限制在-18~2dBm,最大输出功率20dBm,增益范围为13~25dB,噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify. Requirement: 1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km. 2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm. 3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)
    2019-05-13 09:39:41下载
    积分:1
  • 改良克
    modified Gram-Schmidt (reduced QR factorization). A is a m-by-n matrix(m>=n)
    2022-09-23 05:35:03下载
    积分:1
  • Induction-machine-scalar-control
    This file contains the scalar control for induction machine. This is a Matlab simulation.
    2012-07-07 14:33:01下载
    积分:1
  • MRI-Slicer
    MATLAB MRI Slicer, Move MRI Slices to 3D
    2012-07-14 13:25:54下载
    积分:1
  • visualiza_Boundary_condition_annulus
    Boundary condition annulues
    2014-11-26 18:18:12下载
    积分:1
  • demodulator
    Demodulation of OFDMA.
    2015-03-12 13:50:07下载
    积分:1
  • GPS Software Receiver matlab code GPS接收机
    这是一个国外著名书籍后面符的程序,可以实现GPS信号的提取、捕获、跟踪、定位功能。输出定位结果,以及卫星PRN号、信号相关频谱等内容。对于GPS接收机模拟仿真以及抗干扰能力研究具有很高的参考价值,先分享给大家。
    2023-06-06 23:10:02下载
    积分:1
  • 696518资源总数
  • 104321会员总数
  • 14今日下载