登录
首页 » matlab » matlabandDCTwatermarking

matlabandDCTwatermarking

于 2010-10-12 发布 文件大小:1KB
0 114
下载积分: 1 下载次数: 3

代码说明:

  matlab编写的DCT域数字水印,适合初学者学习借鉴(DCT Watermarking by matlab)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论


0 个回复

  • dwmusic
    本程序为多维面阵的波达方位估计的程序,用于面阵俯仰角方位角定向(DOA DOA estimation procedures for multi-dimensional planar array of procedures for the azimuth orientation of the pitch angle of the plane array)
    2012-08-31 20:01:03下载
    积分:1
  • PVsystem
    Simulation model of solar energy system used in modelling of renewable hybrid energy power system
    2015-03-29 22:09:23下载
    积分:1
  • SampEn
    样本熵,用于进行信号的复杂度计算,已调试完成,可直接调用(sample entropy can be used to analyze the complexity of signal.)
    2017-07-31 15:40:24下载
    积分:1
  • wodega
    说明:  一些变异的遗传算法的matlab的程序实现,一些源码,关于ga的工具箱的实现(Some genetic algorithms matlab program implementation, a number of source code,)
    2010-03-22 16:02:04下载
    积分:1
  • 910
    说明:  思源科技出版 matlab基础与提高 9-10章 源代码(Si Yuan Foundation and enhance the scientific publishing matlab source code chapter 9-10)
    2010-04-24 11:57:28下载
    积分:1
  • Matlab_zuixiaoerchengfa
      最小费用最大流算法通用Matlab函数 基于Floyd最短路算法的Ford和Fulkerson迭加算法   基本思路:把各条弧上单位流量的费用看成某种长度,用Floyd求最短路的方法确定一条   自V1至Vn的最短路 再将这条最短路作为可扩充路,用求解最大流问题的方法将其上的流   量增至最大可能值 而这条最短路上的流量增加后,其上各条弧的单位流量的费用要重新   确定,如此多次迭代,最终得到最小费用最大流.( Minimum cost maximum flow algorithm for general Matlab functions based on the Floyd shortest path algorithm of Ford and Fulkerson superposition algorithm of the basic ideas: the cost of unit flow on the arc as a certain length of Floyd for the most short-circuit method to determine the one percent V1 through Vn are the most short-circuit then this short circuit as a scalable road, a method for solving the maximum flow problem on flow increased to the maximum possible value that the shortest way increased traffic, the cost of unit flow on each arc sure, so many iterations, the final minimum cost maximum flow.)
    2012-07-27 14:54:17下载
    积分:1
  • zhichixiangliangji1
    基于MATLAB利用Particle-in-cell模型,对梯形管内壁等离子体离子注入过程,进行了二维数值模拟.计算结果表明在中心电极附近出现了“阳极鞘层”,该鞘层内部不存在离子,而且在鞘层边缘离子密度最高.在上下管壁上的离子注入剂量呈现“m”形分布.通过对注入过程中等离子体密度分布和不同时间段管壁不同位置离子注入剂量的跟踪,发现“阳极鞘层”扩展行为是导致“m”形分布的原因.由于梯形管形状的不对称性,“阳极鞘层”的边缘向梯形长底方向扩展较快.在注入初始时刻离子注入的能量很低,随着时间延长离子能量逐渐升高,这是由离子初始位置决定的.可见梯形管自身形状决定了鞘层形状和最终的离子注入能量和剂量分布.(Based on MATLAB use Particle-in-cell model, the trapezoidal pipe wall plasma ion implantation process, the numerical simulation of two-dimensional calculation results show that in the vicinity of the center electrode to a "anode sheath," which does not exist inside the plasma sheath, and the highest in the sheath edge ion density ion implantation dose showing the upper and lower walls of the "m"-shaped distribution through the process of injecting the plasma density distribution and the wall at different locations in different time periods ion implantation dose tracking, found that "anode sheath "extension behavior is leading to" m "-shaped distribution of the reasons due to the asymmetry of the trapezoidal shape of the tube," Edge anode sheath "extension to the end of a long trapezoid direction quickly in the initial moment of implantation energy ion implantation is low ion energy with time gradually increased, which is determined by the initial position of the ion. visible trapezoida)
    2014-01-09 14:08:57下载
    积分:1
  • GAN-Base-on-Matlab-master
    在matlab上面实现GAN,能够完成简单的GAN操作。(The implementation of GAN on Matlab can accomplish simple GAN operation.)
    2020-06-17 16:40:02下载
    积分:1
  • 混沌映射特性
    tent帐篷映射分岔图 Henon映射 matlab 运行可直接看图(tent map, bifurcation graphs for a tent and henon system)
    2021-04-10 11:08:59下载
    积分:1
  • X_LMSmatlab
    基于lms算法的X-LMS算法,比较适合实际模型(LMS algorithm based on X-LMS algorithm, more suitable for the actual model)
    2008-03-27 09:33:13下载
    积分:1
  • 696518资源总数
  • 104730会员总数
  • 34今日下载