-
直流电动机驱动器设计开发环境为ICC,可以编译成汇编,直接下栽到嵌入式avr单片机进行控制...
直流电动机驱动器设计开发环境为ICC,可以编译成汇编,直接下栽到嵌入式avr单片机进行控制-DC motor drive design and development environment for the ICC, can compile a compendium, Embedded directly to the downward avr microprocessor control
- 2022-05-01 00:06:50下载
- 积分：1
-
多功能电子秒表，用于单片机的学习，实现秒表的功能
多功能电子秒表，用于单片机的学习，实现秒表的功能-Multi-function electronic stopwatch for single-chip learning, realization of the functions of a stopwatch
- 2023-05-06 22:45:02下载
- 积分：1
-
This is the msp430 time b of the routine, please check, then there
这是msp430 time b的例程，请查收，接下来还有-This is the msp430 time b of the routine, please check, then there
- 2023-02-06 22:40:03下载
- 积分：1
-
MipsCPU based on the UART communication procedures, in the u
基于MipsCPU的UART通讯程序，在u-boot下运行。-MipsCPU based on the UART communication procedures, in the u-boot run.
- 2022-01-25 13:59:45下载
- 积分：1
-
51单片机C语言的编程技巧
在进行单片机应用系统设计时．汇编语言是一种常用的软件工具。它能直接操作硬件．指令的执行速度快。但其指令繁育统的固有格式受硬件结构...
51单片机C语言的编程技巧
在进行单片机应用系统设计时．汇编语言是一种常用的软件工具。它能直接操作硬件．指令的执行速度快。但其指令繁育统的固有格式受硬件结构的限制很大．且难于编写与调试．同时其可移植性也较差。随着单片机硬件性能的提高．其工作速度越来越快．因此在编写单片机应用系统程序时．更着重于程序本身的编写效率。本文介招的C51交叉编译器就是解决连一问题的利器-51 microcontroller C programming language skills during SCM application system design. Assembly Language is a common software tools. It can directly operate the hardware. Order Execution speed. But their breeding EC Directive format by the inherent structural limitations of hardware great. It is not easy to prepare and debugging. While its portability also poor. With SCM performance of hardware. Their work ever faster. Therefore, in preparing microcontroller applications procedures. More focused on the preparation process itself efficiency. This paper introduces the C51 cross compiler is not even solve the problem of a sharp object
- 2022-01-24 18:05:39下载
- 积分：1
-
c8051f340 USB传输 固件驱动， c8051f340 USB传输 固件驱动，
c8051f340 USB传输 固件驱动， c8051f340 USB传输 固件驱动，-transmission c8051f340 USB drive firmware, c8051f340 USB transmission firmware-driven,
- 2022-02-03 03:01:49下载
- 积分：1
-
6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1），
K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都...
6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1），
K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用
-6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention
- 2022-08-13 14:18:02下载
- 积分：1
-
RAM的硬件测试程序,经本人测试已经没有问题
RAM的硬件测试程序,经本人测试已经没有问题-RAM hardware test procedures, as I have no problem testing
- 2023-05-22 18:30:02下载
- 积分：1
-
基于avr单片机的，spi接口的sd卡读写源程序
基于avr单片机的，spi接口的sd卡读写源程序-based avr MCU, 20 interface sd card reader source
- 2022-08-16 16:56:16下载
- 积分：1
-
use the main mode I2C CAT24WC02 to write 10 bytes of data, and then read out the...
使用主模式I2C向CAT24WC02写入10字节数据，然后读出校验，若校验通过则BEE发声，否则不断BEE。
基于ADS1.2-use the main mode I2C CAT24WC02 to write 10 bytes of data, and then read out the check, if the check is through BEE audible, constantly BEE. Based on ADS1.2
- 2022-03-21 10:55:27下载
- 积分：1
