登录
首页 » SCM » SCM STC IAP procedures, using C51 write is from the compilation of the conversio...

SCM STC IAP procedures, using C51 write is from the compilation of the conversio...

于 2022-08-21 发布 文件大小:35.48 kB
0 61
下载积分: 2 下载次数: 1

代码说明:

stc单片机的iap程序,用c51写的,是从汇编转换过来的-SCM STC IAP procedures, using C51 write is from the compilation of the conversion from the

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • ARM LPC2103在LCD12864驱动,直臂的转换功能的使用,D.
    ARM LPC2103下的LCD12864驱动程序,直接采用ARM的SPI0功能,开发环境为ADS,工程可以下载直接使用。-ARM LPC2103 under LCD12864 driver, direct the use of ARM s SPI0 functionality, development environment for the ADS, the project can be downloaded directly used.
    2022-05-08 04:52:32下载
    积分:1
  • 基于tw2835的的相关源代码程序,由一款51单片机来控制
    基于tw2835的的相关源代码程序,由一款51单片机来控制-Tw2835-based source code of the relevant procedures, by a single-chip microcomputer 51 to control the
    2022-02-20 15:39:02下载
    积分:1
  • Ti 公司低功耗RF芯片选型资料.其中有13.56
    Ti 公司低功耗RF芯片选型资料.其中有13.56-27MHz,300-1000MHz ,2.4GHz等等芯片选型参考-Ti low-power RF chip companies Selection information. Among them, 13.56-27MHz ,300-1000MHz, 2.4GHz chip, etc. Selection of reference
    2022-02-16 05:55:48下载
    积分:1
  • 44780字符液晶屏驱动演示程序总线方式
    44780字符液晶屏驱动演示程序总线方式-44,780 Character LCD Driver Bus Demonstration Program
    2022-01-24 08:54:56下载
    积分:1
  • 关于51单片机的ucos
    关于51单片机的ucos-II操作系统移植论文,详细介绍简单操作系统的移植硬件知识和CPU结构知识及单片机软件编程技巧-About 51 MCU ucos-II operating system migration papers, details of a simple migration of hardware, operating system, CPU structure of knowledge and the knowledge and SCM software programming skills
    2022-04-09 09:12:11下载
    积分:1
  • 本文件介绍了MSC51与AVR单片机的区别,同时,对它们的区别的使用代码进行了说明...
    本文件介绍了MSC51与AVR单片机的区别,同时,对它们的区别的使用代码进行了说明-This document presents the AVR microcontroller with MSC51 distinction, at the same time, the difference between their use of the code described
    2022-02-20 15:46:03下载
    积分:1
  • The design of single
    本设计的由单片机控制的自动加料系统是与料斗式干燥机配套的加料系统。根据加料工艺要求,其工作原理是:先将真空管关闭,启动电机,用低真空气流将塑料树脂粒子送入真空管,电机停转,再将粒子排入料斗,如此循环。-The design of single-chip microcomputer controlled by the automatic feeding system with hopper dryer feed supporting system. Charging process in accordance with the requirements of its working principle is: first vacuum tube to close, start motor, using low vacuum plastic resin particles will flow into the vacuum tube, the electrical switch to stop, and then particles into the hopper, and so the cycle.
    2022-05-27 04:59:44下载
    积分:1
  • QG8_demo学习板开发板例程 i2c的例程,辛苦找来。 经过验证是正确的。...
    QG8_demo学习板开发板例程 i2c的例程,辛苦找来。 经过验证是正确的。-Board development board QG8_demo learning routines i2c routine, it is tough to get a large. Verified to be correct.
    2022-01-24 17:56:47下载
    积分:1
  • dual audio decoder di drives with Serial receive data from the serial debugger v...
    双音频解码器MT8870的驱动,用串口接收数据,可从串口调试器查看接收的数据-dual audio decoder di drives with Serial receive data from the serial debugger view of the data received
    2022-04-22 03:03:49下载
    积分:1
  • complete decoder based on the use of electronic calendar SCM, detailed and truth...
    很完整使用的基于c51单片机的电子万年历,详细无误!-complete decoder based on the use of electronic calendar SCM, detailed and truthful!
    2022-12-19 09:35:03下载
    积分:1
  • 696518资源总数
  • 104269会员总数
  • 31今日下载