-
cd4094驱动程序，驱动共阴极数码管，单片机作为控制器，…
cd4094驱动程序，驱动1位共阴极数码管，pic12c508a作为控制器，gp0-gp2分别为data,clk,strobe.-cd4094 drivers, driving a total digital cathode tubes, pic12c508a as controller, gp0-Day for data, clk, strobe.
- 2022-03-23 11:43:06下载
- 积分：1
-
PHILIPS P87C591 PeliCan C语言开发库，极大方便了对591的CAN开发。
PHILIPS P87C591 PeliCan C语言开发库，极大方便了对591的CAN开发。-PHILIPS P87C591 PeliCan C language library, a great convenience for the development of CAN 591.
- 2023-07-15 18:55:04下载
- 积分：1
-
Keil C51软件模拟I2C基于主线
keil c51下基于软件模拟I2C总线的Dll动态连接库。下载后将其烤到keilC51in下即可。-keil c51 simulates I2C based on software the main line the
Dll dynamic connection storehouse. After downloading roasts it to
keilC51in under then.
- 2022-12-01 13:15:08下载
- 积分：1
-
使用PIC12C508509的例程：用PIC12C508509 控制一个步进电机源程序，用PIC12C508A 控制模型源程序和用PIC12C509 控制LED...
使用PIC12C508509的例程：用PIC12C508509 控制一个步进电机源程序，用PIC12C508A 控制模型源程序和用PIC12C509 控制LED。-an example program about PIC12C508509: use PIC12C508509to control stepping motor, use PIC12C508A controlling model source and PIC12C509 control LED
- 2022-03-03 16:44:37下载
- 积分：1
-
myson 单片机cs8954 demo code!
myson 单片机cs8954 demo code!-SCM cs8954 demo code!
- 2022-05-05 13:57:44下载
- 积分：1
-
遥控信号的接收程序，可以接收红外遥控信号，控制功放的音量等信息。...
遥控信号的接收程序，可以接收红外遥控信号，控制功放的音量等信息。-Remote control signal reception procedures, can receive infrared remote signals to control the volume of information such as power amplifier.
- 2023-07-23 07:00:04下载
- 积分：1
-
玩具小车，设计，AT85c52,c语言设计，无线控制
玩具小车，设计，AT85c52,c语言设计，无线控制-toy car, design, AT85c52, c language design, wireless control
- 2022-04-18 04:47:34下载
- 积分：1
-
an embedded system via GPRS for data transfer procedures, the agreement for the...
一个嵌入式系统通过GPRS进行数据传输的程序，协议为5112芯片，其中描述了单片机采用UDP上网和数据传输的过程
- 2022-10-03 21:55:04下载
- 积分：1
-
IC Card operating software : AT88SCl604 chip mode of operation there are five. T...
IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta
- 2022-05-28 08:23:00下载
- 积分：1
-
数字波形发生器,能够产生同步的几个方波.
数字波形发生器,能够产生同步的几个方波.-digital waveform generator capable of producing several square synchronization.
- 2022-04-28 09:47:13下载
- 积分：1
