本文为采用VHDL编写的程序及报告。步骤如下：1设计三位二进制计数器程序 二:设计一驱动循环显示7位数字 2编写LED控制程序如下： 3设计采用原理图方式如下: -VHDL paper prepared for the introduction of procedures and reports. Steps are as follows : Design of a binary counter three two procedures : Design of a drive cycle show seven figures prepared two LED control procedures are as follows : three designs diagram as follows :

small rtos 1.20 一套单片机嵌入式操作系统,由陈明计开发-small rtos 1.20 a single-chip embedded operating system, developed by Chen dollars

一个开源的linux video摄像头程序-an open-source Linux video camera procedures

液滴的自动控制装置，采用步进电极控制上下运动-Auto-controller of liquid drop, use stepping motor control movement up and down.

本系统利用集成智能温度传感器测量温度，采用光纤传输温度信号。系统由单片机（HT46R24）控制温度传感器（DS18B20）的温度采集。当有采集温度的指令的时候，才启动温度传感器并采回其数据，在没有进行温度采集的时候，将通过抬高温度传感器的地，关断其工作电源，如此可以降低系统的功耗。系统将每一次采集回来的数据与前一次的数据比较，若温度变化超限或温升超标，立即发送上述温度值；否则，累加到采集了一定的次数，再向主机发送最新温度值。-The system uses an integrated smart temperature sensors measure temperature, using optical fiber transmission temperature signal. System consists of microcontroller (HT46R24) controlling the temperature sensor (DS18B20) the temperature of collection. When a collection of instructions, when the temperature before start-up temperature sensors and taken back to its data, collected in the absence of the temperature when the temperature sensor will raise, the turn-off the power of their work, so you can reduce system power consumption. The system will come back every time collecting data and previous data comparison, if the temperature changes or temperature exceeding overrun immediately send the temperature value otherwise accumulate to collect a certain number of times, again

MS430+FM1702y读卡器程序,读写寄存器和卡.-MS430+ FM1702y reader program, reading and writing registers and cards.

MIZI LINUX 嵌入式操作系统-FTE embedded Linux operating system

英培特ARM教学平台EDUKIT-III，核心子板为s3c2410，在RH9下实现的sdram测试程序。-British培特ARM teaching platform EDUKIT-III, the core sub-board for s3c2410, in RH9 realize the SDRAM under test procedures.

应用背景飞思卡尔单片机hcs12中文资料，介绍16位mcu的使用，编程关键技术可用于飞思卡尔智能车设计大赛中的单片机开发参考，详细介绍pwm模块的操作等

3D光立方自己亲自调试的源码，硬件已经实现通过的，可现实倒计时，螺旋函数可以实现，目前就是没有把音频程序添加