登录
首页 » SCM » MS51单片机的一些设计包含原理图和源代码,可在proteus下仿真。。 备注:这些设计的源码是使用汇编语言编写的。...

MS51单片机的一些设计包含原理图和源代码,可在proteus下仿真。。 备注:这些设计的源码是使用汇编语言编写的。...

于 2022-07-13 发布 文件大小:856.00 B
0 46
下载积分: 2 下载次数: 1

代码说明:

MS51单片机的一些设计包含原理图和源代码,可在proteus下仿真。。 备注:这些设计的源码是使用汇编语言编写的。-MS51 MCU contains a number of design schematics and source code, under the simulation in Proteus. . Note: these designs is to use the compilation of the source language.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 串口通讯实现发送的程序 MSP430单片机C语言 AIR
    串口通讯实现发送的程序 MSP430单片机C语言 AIR-Serial Communication MSP430 realization procedures sent Singlechip C language AIR
    2023-03-23 17:40:04下载
    积分:1
  • 我最近找的一些关于ADS1252的资料,还有源码,我已经编译过啦
    我最近找的一些关于ADS1252的资料,还有源码,我已经编译过啦-Recently, I find some of the information on the ADS1252, and the source code, I have compiled Matata
    2022-03-23 00:39:57下载
    积分:1
  • 完整的俄罗斯方块程序及(Proteus)仿真 很值得看哦
    完整的俄罗斯方块程序及(Proteus)仿真 很值得看哦-Complete procedures and Tetris (Proteus) is worthy of emulation看哦
    2022-03-15 00:55:52下载
    积分:1
  • ADC0832 端口复用 8数码管显示 初学ADC及单片机的助手 有 proteus 仿真电路...
    ADC0832 端口复用 8数码管显示 初学ADC及单片机的助手 有 proteus 仿真电路-ADC0832-port multiplexing 8 digital tube display beginners ADC and the microcontroller" s aides have proteus simulation circuit
    2023-05-09 06:25:02下载
    积分:1
  • 单片机与ALTEC温控仪的通讯,设置温度。
    单片机与ALTEC温控仪的通讯,设置温度。-Single-chip temperature controller with ALTEC communication, set the temperature.
    2022-01-26 08:15:35下载
    积分:1
  • 在AVR上实现USB的功能,是模拟出的USB
    在AVR上实现USB的功能,是模拟出的USB-In the AVR to achieve USB functionality of USB is to simulate the
    2022-01-26 03:12:02下载
    积分:1
  • 2022-01-26 02:12:59下载
    积分:1
  • ds1302应用实例 烧进单片机即可应用 不看后悔
    ds1302应用实例 烧进单片机即可应用 不看后悔-ds1302 Applications can be burned into the microcontroller application Bukanhouhui
    2022-06-02 00:30:00下载
    积分:1
  • IC Card operating software : AT88SCl604 chip mode of operation there are five. T...
    IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作: AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位: 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位: 当CLK为低时,在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位,而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta
    2022-05-28 08:23:00下载
    积分:1
  • 一个读写器的读卡器源代码,单片机接口全部输入输出,低…
    一个CPU卡读卡器源代码,接口全部由单片机IO模拟实现,成本极低-a CPU card reader source code, microcontroller interface all IO simulation, low cost
    2023-05-04 16:20:03下载
    积分:1
  • 696521资源总数
  • 104062会员总数
  • 3今日下载