-
设计应用接口作为16位二进制编码器的输出口，并用该接口作为LED七段显示器的输出口,循环显示编码结果...
设计应用接口作为16位二进制编码器的输出口，并用该接口作为LED七段显示器的输出口,循环显示编码结果-Application Interface Design as a 16-bit binary encoder output, and the interface as a Seven-Segment LED display output cycle coding results show
- 2022-01-26 06:23:49下载
- 积分：1
-
C8051F06X series SCM documentation, including a detailed C8051F06X SCM applicati...
C8051F06X系列单片机的说明文档，其中包括了C8051F06X单片机详细的适用说明及编程时需要考虑的问题-C8051F06X series SCM documentation, including a detailed C8051F06X SCM application programming note and the need to consider the issues
- 2022-01-22 06:11:00下载
- 积分：1
-
硬盘作MP3,用IDE接口的旧硬盘,加入51系列的单片机和显示屏,可以作一个有个性的MP3,...
硬盘作MP3,用IDE接口的旧硬盘,加入51系列的单片机和显示屏,可以作一个有个性的MP3,-Hard drive for MP3, using the old IDE interface hard drives, adding 51 series of single-chip computer and display, can be used as a personality MP3,
- 2022-04-20 15:33:46下载
- 积分：1
-
The traffic light is timed and lets cars pass during a
specific time period. T...
The traffic light is timed and lets cars pass during a
specific time period. There is a pedestrial crossing
button that lets pedestrians cross. The lights are
connected to Port 1. You can see this in action using
dScope.
- 2023-04-11 02:25:04下载
- 积分：1
-
pc与51单片机的快速串行通信程序。开发环境KeilC
pc与51单片机的快速串行通信程序。开发环境KeilC-pc with 51 single-chip fast serial communication program. Development environment KeilC
- 2022-03-17 06:25:09下载
- 积分：1
-
IC Card operating software : AT88SCl604 chip mode of operation there are five. T...
IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta
- 2022-05-28 08:23:00下载
- 积分：1
-
MSC1210单片机的一个监控程序，
MSC1210单片机的一个监控程序，-MSC1210 of a monitoring program,
- 2022-04-20 08:31:03下载
- 积分：1
-
Keil C51 microprocessor development tools Guide
Keil C51微处理器开发工具使用指南-Keil C51 microprocessor development tools Guide
- 2022-04-08 23:51:52下载
- 积分：1
-
ads1110 applications, hope that this procedure can be helpful to everyone
ads1110的应用程序，希望此程序能给大家带来帮助-ads1110 applications, hope that this procedure can be helpful to everyone
- 2023-03-02 15:25:04下载
- 积分：1
-
利用51单片机控制红外遥控的发射部分的程序，该程序在51单片机的基础上，采用一定的协议，进行编码、调制和发送等，具有很实用的价值。...
利用51单片机控制红外遥控的发射部分的程序，该程序在51单片机的基础上，采用一定的协议，进行编码、调制和发送等，具有很实用的价值。-51 SCM control the use of infrared remote control transmitter of the program, the program in MCS-51, based on the use of certain agreements, coding, modulation and delivery and so on, have a very practical value.
- 2023-06-15 21:00:02下载
- 积分：1
