-
IC 读写功能 代码仅供参照 针对加密卡的功能读写程序
IC 读写功能 代码仅供参照 针对加密卡的功能读写程序 -IC function to read and write code for reference for the function of encryption cards to read and write procedures
- 2023-08-29 17:35:03下载
- 积分：1
-
这是嵌入式usb驱动的源码,仅供参考,可花费了好长时间才调通的...
这是嵌入式usb驱动的源码,仅供参考,可花费了好长时间才调通的-This is embedded usb driver source for reference purposes only and may spend a good long time to tune
- 2022-08-18 18:39:46下载
- 积分：1
-
FPGA verilog PS2 鼠标控制LED
FPGA verilog PS2 鼠标控制LED PS2接收模块（电脑接收，鼠标发送） PS2_CLK信号由PS2设备产生,即鼠标在产生时钟的同时向主机送出数据，主机在PS2_CLK信号的下降沿读取(锁存)每个位。/*标准的鼠标有两个计数器保持位移的跟踪:X位移计数器和Y位移计数器。**可存放9位的2进制补码，并且每个计数器都有相关的溢出标志。**它们的内容连同三个鼠标按钮的状态一起以三字节移动数据包的形式发送给主机。**位移计数器表示从最后一次位移数据包被送往主机后有位移量发生。**位移计数器是一个9位2的补码整数。它的最高位作为符号位出现在位移数据包的第一个字节里。
- 2022-07-12 01:00:10下载
- 积分：1
-
嘟嘟使用keil程序代码。
beep use keil to program this code.
- 2022-03-04 12:27:41下载
- 积分：1
-
登陆注册
登陆注册登陆注注册注册注册注册注册注册注册注册
- 2022-05-17 23:11:03下载
- 积分：1
-
A simple preoteus based design to display the characters typed int the keyboard...
A simple preoteus based design to display the characters typed int the keyboard into LCD using UART of 8051.Plz make sure that TTL to RS232 is inserted in between the microcontroller and virtual terminal which is not shown in the design.
- 2022-05-31 21:18:35下载
- 积分：1
-
Outside the extended ram
外扩ram-Outside the extended ram
- 2023-07-03 12:50:03下载
- 积分：1
-
韦根协议实现和用io模拟串口实现
韦根协议实现和用io模拟串口实现-Wageningen protocol and the use of simulated io Serial Port
- 2022-07-13 21:08:50下载
- 积分：1
-
NiosII_SOPCBuilder_Class ppt演示文稿
NiosII_SOPCBuilder_Class ppt演示文稿-NiosII_SOPCBuilder_Class ppt presentation
- 2022-05-14 12:39:04下载
- 积分：1
-
DE2 练习源码2-1
Part I
We wish to display on the 7-segment displays HEX3 to HEX0 the values set by the switches SW15−0. Let the
values denoted by SW15−12, SW11−8, SW7−4 and SW3−0 be displayed on HEX3, HEX2, HEX1 and HEX0,
respectively. Your circuit should be able to display the digits from 0 to 9, and should treat the valuations 1010 to
1111 as don’t-cares.
1. Create a new project which will be used to implement the desired circuit on the Altera DE2 board. The
intent of this exercise is to manually derive the logic functions needed for the 7-segment displays. You
should use only simple VHDL assignment statements in your code and specify e
- 2022-03-23 22:31:42下载
- 积分：1
