-
Using 8
采用8位LED动态扫描时钟演示程序，使用12MHZ晶振，P0口输出段码，P2口作列扫描，用共阳LED数码管。-Using 8-bit dynamic scanning LED clock demonstration, the use of 12MHZ crystal, P0 port output above code, P2 scan I made out with a total of LED digital tube Yang.
- 2022-09-13 02:30:06下载
- 积分：1
-
A simple
简单的"祝你生日快乐"歌曲
芯片为mega8-A simple
- 2023-04-13 10:10:04下载
- 积分：1
-
AT29C040 in MCU that the application enables users to quickly achieve the requir...
AT29C040在单片机中的应用不仅能使用户快速地实现所需功能，而且电擦除的方式为程序和数据的存储和更新提供了方便，随着闪速存储器器件朝着容量越来越大、工作电压越来越低、支持共同的接口标准的方向发展，闪速存储器硬件接口和软件设计将越来越容易。 -AT29C040 in MCU that the application enables users to quickly achieve the required functions, but also-- in the form of erasure and data storage and update provides a convenient, as Flash memory devices towards increasing capacity, low voltage increasingly support a common interface standard direction, Flash memory interface hardware and software design will become increasingly vulnerable.
- 2023-06-02 06:55:04下载
- 积分：1
-
IC Card operating software : AT88SCl604 chip mode of operation there are five. T...
IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta
- 2022-05-28 08:23:00下载
- 积分：1
-
SCM MarqueeSCM MarqueeSCM MarqueeSCM MarqueeSCM Marquee 51 sniperlm
SCM MarqueeSCM MarqueeSCM MarqueeSCM MarqueeSCM 51狙击手
- 2022-08-17 07:33:20下载
- 积分：1
-
Proteus仿真实例，在Proteus下仿真液晶显示器，你可以使用…
Proteus仿真实例，在Proteus下仿真LCD,可以使用，郑重推荐！-Proteus simulation example, in the Proteus simulation under the LCD, you can use, solemnly recommended!
- 2023-06-25 08:50:03下载
- 积分：1
-
基于51单片机的直流电机的闭环控制Design for a Closed
基于51单片机的直流电机的闭环控制Design for a Closed-loop Speed Control of DC Motor-Based on 51 single-chip closed-loop DC motor control Design for a Closed-loop Speed Control of DC Motor
- 2022-08-25 21:08:45下载
- 积分：1
-
义隆单片机读写24C**
** 24CXX 接口I2C总线读/写的程序
** （所有时序均基于4MHZ晶体震荡器频率）...
义隆单片机读写24C**
** 24CXX 接口I2C总线读/写的程序
** （所有时序均基于4MHZ晶体震荡器频率）-Elan Single-chip 24C**** 24CXX read and write I2C bus interface read/write procedures** (All timing are based on the frequency of 4MHz crystal oscillator)
- 2022-08-10 10:12:55下载
- 积分：1
-
* 功能：使用PWM6输出PWM信号，通过滤波电实现DAC转换。由KEY1控制PWM的占空比，
* 每按一次按键将会改变一次PWM的占空比。
* 说明：...
* 功能：使用PWM6输出PWM信号，通过滤波电实现DAC转换。由KEY1控制PWM的占空比，
* 每按一次按键将会改变一次PWM的占空比。
* 说明：使用示波器观察测试点PWM和PWMDAC。-* Function: Use PWM6 output PWM signal, by filtering electrical realize DAC conversion. Key1 controlled by the PWM duty cycle,* every time a button will change the PWM duty cycle.* Note: Use the oscilloscope to observe test points PWM and PWMDAC.
- 2022-05-18 17:52:46下载
- 积分：1
-
这是致远电子
MagicARM2410实验箱上基础实验的步进电机编程原代码...
这是致远电子
MagicARM2410实验箱上基础实验的步进电机编程原代码-This is the electronic MagicARM2410 Jhihyuan me on the basis of experimental trials stepper motor programming source code
- 2022-03-07 14:03:13下载
- 积分：1
