-
snrCALCULATION
DAM SIMPLE CODE FOR NAVICE USER SO ENJOY IT.. . . .
- 2009-11-23 21:44:17下载
- 积分：1
-
bianyi
实现语音信道编码之卷积编码的编译码仿真程序，采用的是维比特编码(Voice channel coding convolutional coding of the codec simulation program, using the bit-dimensional coding)
- 2009-05-15 10:07:03下载
- 积分：1
-
STBC
程序中以一根接收天线为例，分别对一根发射天线、两根发射天线、三根发射天线和四根发射天线系统进行STBC仿真。比较误码率性能。(Program to a receiving antenna, for example, a transmitting antenna, respectively, the two transmit antennas, three transmit antennas and four transmit antenna system STBC simulation. Compare the bit error rate performance.)
- 2021-03-25 22:59:13下载
- 积分：1
-
PMET0
用于计算参考作物蒸发蒸腾量ET0(P-M公式)(Used to calculate the reference crop evaporation transpiration ET0)
- 2015-01-26 15:38:19下载
- 积分：1
-
osvm
matlab codes for online SVM
- 2011-12-27 14:16:23下载
- 积分：1
-
Boost_Converter
说明： 升压转换器是一种DC / DC电源转换器，可将电压从其输入（源）升至其输出（负载）。在连续导通模式下（流经电感的电流永远不会降为零），升压转换器的理论传递函数为：
占空比在哪里0.5
在此示例中，转换器从250 V电源馈送RC负载，并且PWM频率设置为31 kHz。
模拟
运行仿真并观察示波器上的波形。确认负载电压（Vout）的平均值非常接近理论值：Vout = 250 /（1- 0.5）= 500V。(A boost converter is a DC/DC power converter which steps up voltage from its input (source) to its output (load). In continuous conduction mode (current through the inductor never falls to zero), the theoretical transfer function of the boost converter is:
where is the duty cycle.0.5
In this example, the converter is feeding an RC load from a 250 V source and the PWM frequency is set to 31 kHz.
Simulation
Run the simulation and observe waveforms on Scope. Verify that the mean value of the load voltage (Vout) is very close to the theoretical value of: Vout = 250 / (1 - 0.5) = 500 V.)
- 2020-03-22 20:41:56下载
- 积分：1
-
FittingSurvivalModelss
Companion code for Fitting Survival Probability Models article
- 2010-10-18 16:17:25下载
- 积分：1
-
matlab-(2)
稀疏表示的matlab小程序，欢迎来联合开发网下载！(Sparse representation matlab small procedures, welcome to the Joint Development Network download!)
- 2013-10-26 12:45:02下载
- 积分：1
-
po-slovensky-nieco
matlab po slovensky nieco
- 2013-11-11 01:54:39下载
- 积分：1
-
可以编译的超像素图像分割算法代码
包括调制，解调，信噪比计算，采用了小波去噪的思想，光纤陀螺输出误差的allan方差分析，仿真图是速度、距离、幅度三维图像，做视觉测量的上位机代码,包含收发两个客户端程序。
- 2022-02-03 17:56:29下载
- 积分：1
