-
开源串口利用Xmodem,Ymodem,ZModem 下载,上传的程序.在Linux,Arm
开源串口利用Xmodem,Ymodem,ZModem 下载,上传的程序.在Linux,Arm-Linux 都可使用-Open serial port using Xmodem, Ymodem, ZModem download, upload procedure. In Linux, Arm-Linux can be used
- 2022-08-13 12:28:55下载
- 积分：1
-
大学汇编课程设计程序及文档（双机串口文件传输）,开发环境TurboC...
大学汇编课程设计程序及文档（双机串口文件传输）,开发环境TurboC-compilation of the University of curriculum design procedures and documentation (two aircraft serial file transfer), the development environment TurboC
- 2022-07-16 06:21:09下载
- 积分：1
-
RS232控制软件
RS232 control software
- 2022-03-17 19:48:10下载
- 积分：1
-
串行接口通讯试验该试验可以学习如何编写一个通讯程序。这个试验能够实现的功能很简单，仅仅作为试验用。工作环境为：无需其余任何环境，直接接通电源即可。...
串行接口通讯试验该试验可以学习如何编写一个通讯程序。这个试验能够实现的功能很简单，仅仅作为试验用。工作环境为：无需其余任何环境，直接接通电源即可。-serial communication interface test of the pilot can learn how to prepare a communication process. The pilot function can be achieved is very simple, just to experiment with. The working environment : the environment without any rest, can be directly connected to power.
- 2022-04-16 23:18:02下载
- 积分：1
-
check if COmPort is Available
check if COmPort is Available
- 2022-09-08 22:00:02下载
- 积分：1
-
Kermit协议的嵌入式系统上使用kermit协议与PC机传输的做…
kermit protocol 嵌入式系统使用kermit协议,与pc传送文件. 可方便的使用windows 超级终端等.-Kermit protocol embedded systems use Kermit agreement with pc transmission of documents. To facilitate the use of windows Super terminals.
- 2022-02-03 16:57:11下载
- 积分：1
-
通过设置发送并接收消息：可以设置端口，波特率，奇偶校验等参数...
通过设置发送并接收消息：可以设置端口，波特率，奇偶校验等参数-send and receive news : you can set ports, baud rate, parity and other parameters
- 2022-02-12 12:36:03下载
- 积分：1
-
本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发...
本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.
- 2022-02-02 10:09:18下载
- 积分：1
-
M64双串口代码，C语言，经测试运行稳定
M64双串口代码，C语言，经测试运行稳定-M64 dual serial code, C language, have been tested to run stable
- 2023-03-02 23:55:04下载
- 积分：1
-
CAN program for PIC microprocessor
CAN program for PIC microprocessor
- 2022-04-27 01:14:50下载
- 积分：1
