登录
首页 » Objective-C » IAP

IAP

于 2016-07-10 发布 文件大小:3002KB
0 126
下载积分: 1 下载次数: 9

代码说明:

  STM32F10系列单片机的IAP程序,实现远程升级(STM32F10 MCU IAP program and remotely upgrade)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • LCD
    LCD液晶显示程序,在AT89S52上运行成功,其也可以用于其 他的处理器(LCD liquid crystal display program, run on AT89S52 is successful, it can also be used for the processor)
    2014-11-25 12:44:14下载
    积分:1
  • Lattice
    用138,595控制的点阵,附带两个不同控制方式的源程序以及电路连接图,(With 138,595 dot control, with two different control modes of the source and a circuit connection diagram,)
    2015-08-04 21:41:18下载
    积分:1
  • 1602PAD
    单片机AD功能实例,使用1602显示电压(SCM AD function example, the use of 1602 shows the voltage)
    2014-02-23 12:52:35下载
    积分:1
  • sprc675
    TI 官方光伏逆变器学习资料。一个完整的110V纯正弦波输出逆变器学习资料,软硬件都有。(TI Inverter learning resource.)
    2016-01-13 15:11:50下载
    积分:1
  • 430g2233
    基于430g2233的温度程序,有18B20和PT1000,两种传感器(The temperature program based on 430g2233)
    2014-09-05 14:25:18下载
    积分:1
  • READdht11
    一个能读取DHT11湿度传感器的程序,使用STM8S003K3P6(A program to read DHT11 humidity sensor)
    2015-08-16 19:32:40下载
    积分:1
  • FREQ
    说明:  用mcs-52系列单片机实现等精度频率测量,T1引脚接被测TTL信号,晶振22.1184MHz,对任何频率都可以实现很高精度的测量(精度<1 ),结果从串口字符串输出,波特率115200,可以用串口调试器观察结果.(With mcs-52 family of single chip and other precision frequency measurement, T1 pin then measured TTL signal, Crystal 22.1184MHz, any frequency can be achieved very high accuracy of measurement (precision<1 ), the result string from the serial output , baud rate 115200, serial debugger can observe the results.)
    2010-05-02 16:45:44下载
    积分:1
  • 865476
    与沉默的开关为iOS,精选ios编程学习源码,很好的参考资料。(And the silence of the switch is iOS, select learning IOS programming source code, a good reference.)
    2013-12-08 16:53:01下载
    积分:1
  • diangandianrong
    刚才上传的频率计程序可能不太好,现在这个计数外部脉冲的程序,还是较好的,只是得自己从中截取出来(Just upload the program may not be a good frequency counter, and now this external pulse count procedures, or better, just get yourself out from the interception of)
    2011-11-19 17:06:19下载
    积分:1
  • MSP430FR57xx_01
    MSP430FR57x Demo - Toggle P1.0 using software Description: Toggle P1.0 using software. ACLK = n/a, MCLK = SMCLK = TACLK = default DCO = ~625 KHz(MSP430FR57x Demo- Toggle P1.0 using software Description: Toggle P1.0 using software. ACLK = n/a, MCLK = SMCLK = TACLK = default DCO = ~625 KHz)
    2011-10-07 15:03:56下载
    积分:1
  • 696518资源总数
  • 104226会员总数
  • 47今日下载