-
facerecognitionsystem
其中那个包括边界处理，腐蚀边界的matlab源代码，有需要的(One that includes border deal, corrosion border matlab source code, there is a need of)
- 2007-09-25 20:53:28下载
- 积分：1
-
anfis
ANFIS网络编程环境下的变量选择程序，通过确定非相关性分析挑选适合确定输出的输入变量(ANFIS network programming environment variable selection procedures, by determining the selection of non-correlation analysis to determine the output of the input variables for)
- 2010-07-15 23:02:31下载
- 积分：1
-
hipr
使用push-relabel方法求解最大流问题，是国外的一个研究机构编写的，速度很快。(This is an efficient implementation of the push-relabel method.
See
Goldberg and Tarjan, "A New Approach to the Maximum Flow Problem,"
J. ACM Vol. 35, 921--940, 1988
and
Cherkassky and Goldberg, "On Implementing Push-Relabel Method for the
Maximum Flow Problem," Proc. IPCO-4, 157--171, 1995.)
- 2009-11-23 11:00:19下载
- 积分：1
-
ica
fastica算法，去除眼电，实现对脑电的去噪处理(fastica algorithm to remove the EOG)
- 2020-09-20 15:17:53下载
- 积分：1
-
RaisedCosineFilter
matlab raisedcosine filter
- 2011-10-27 02:40:46下载
- 积分：1
-
OFDM
首先根据短训练字的特性进行相关运算，进行信号到达检测，当检测到相关值大于门限一定次数后，认为有信号到达。然后根据长训练字的特性，进行相关运算，进行OFDM符号FFT窗口起始位置的估计。估计出FFT窗口的位置后，先在时域进行小频偏的估计，将两个长训练字进行小频偏补偿后，进行FFT运算，根据FFT运算的结果进行整数倍频偏的估计。这些参数估计完成后，就可以进行数据解调了。先对数据部分进行完整的频偏补偿，然后根据估计的FFT窗口位置进行FFT运算得到频域的数据，进行解调。然后在对应于导频的子载波位置上提取出导频信息，根据导频信息估计出剩余定时误差以及剩余的信道响应误差，将误差量送入环路进行跟踪。当收到所有数据后，重新回到信号到达检测状态，进行下一次信号到达的检测和信号接收。(First, according to the characteristics of the short training word correlation operation, the signal reaching the detector, when the detected correlation value is greater than the threshold after a certain number of times that a signal arrives. And then the characteristics of long training word, the correlation operation for the FFT window starting position of an OFDM symbol estimate. The estimated position of the FFT window, the first small frequency offset in the time domain estimation, the two long training word small frequency offset compensation, the FFT operation, the FFT result of the operation for integer frequency offset estimate. These parameter estimation is completed, the data can be demodulated on. The first portion of the data for a complete frequency offset compensation, and based on the estimated FFT window position of the FFT operation to obtain frequency domain data, demodulated. Then corresponding to the position of the pilot subcarriers are extracted on pilot inform)
- 2020-11-04 23:49:52下载
- 积分：1
-
hadi-alizade
this is a new alghorithm about tabu search....
- 2013-05-26 16:47:20下载
- 积分：1
-
aerosim_datasheet
The AeroSim blockset provides a complete set of tools for developing
nonlinear 6-degree-of-freedom aircraft dynamic models. The Simulink blocks
include the nonlinear equations of motion, linear aerodynamics based on
component build-up, piston-engine propulsion, aircraft inertia model including
weight variation due to fuel consumption, atmosphere models including
standard atmosphere, wind gusts and von Karman turbulence, Earth models
which provide Earth radius, gravity and magnetic field components at current
aircraft location.
- 2017-01-09 23:19:46下载
- 积分：1
-
4
说明： 现代线性控制理论实验课程的原理，以及有关matlab的例子应用(Modern linear control theory, the principles of experimental program, as well as examples of application of the matlab)
- 2011-07-12 15:57:25下载
- 积分：1
-
bcross
将断层剖面划分为一组网格，并以固定的事件数或固定的扫描半径，计算每个网格点处的b值。然后用色彩表示断层面上b值的分布情况，从而反应断层的应力积累情况，便于地震学家分析该断层是否存在发震的可能(This subroutine creates a grid with spacing dx,dy (in degreees). The size will be selected interactively or grids the entire cross section.
The b-value in each volume is computed around a grid point containing ni earthquakes or in between a certain radius. The standard deviation is calcualted either with the max. likelihood or by bootstrapping, when that box is checked.
If not, both options can be assigned by the additional run assignment.
Standard deviation of b-value in non-bootstrapping case is calculated from Aki-formula!)
- 2011-08-22 12:18:12下载
- 积分：1
