登录
首页 » C51 » TM1651

TM1651

于 2018-06-05 发布 文件大小:1KB
0 185
下载积分: 1 下载次数: 16

代码说明:

  数码管驱动 按键扫描程序,通讯线少 程序模块,简单(Digital tube driver button scanning program, communication line less program module, simple)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • ber_msk_awgn
    msk调制及在AWGN信道中的误码率仿真(MSK modulation and bit error rate simulation in AWGN channel)
    2020-11-14 17:39:42下载
    积分:1
  • BX-5K 5MK user manual
    说明:  BX-5MK2 user manual guide
    2020-06-20 16:40:02下载
    积分:1
  • 该工实现对单载波系统QPSK的频偏估计算法 freq_estimate
    该工程实现对单载波系统QPSK的频偏估计算法。调相信号在接收机相干解调时需要同频同相的参考载波,而发射机和接收机之间往往存在频率偏差,为了消除这种误差,必须在软件层面实现。使用了QPSK四相调制的信号特点进行载波频偏估计,经验证,效果较好。(This project implements frequency offset estimation algorithm for single carrier system QPSK. The phase modulation signal needs the same frequency reference carrier in the coherent demodulation of the receiver, and the frequency deviation often exists between the transmitter and the receiver. In order to eliminate this error, it must be implemented on the software level. The carrier frequency offset estimation is carried out by using the signal characteristics of QPSK four phase modulation.)
    2020-06-27 04:40:01下载
    积分:1
  • HJQE2
    说明:  pcm编码 有关线性,A律,mu律的pcm编码的matlab实现(Matlab implementation of pcm coding for pcm coding related to Linear, A-Law and mulaw)
    2019-03-26 22:28:19下载
    积分:1
  • duopulebuchang
    进行信号积累时,有的信号存在多普勒频率,不利于累加。该程序可完成对信号多谱勒频率的补偿。(Signal accumulation, some signal Doppler frequency, is not conducive to the accumulation. The program can be complete compensation of the signal Doppler frequency.)
    2012-10-30 14:03:45下载
    积分:1
  • test11
    用于变电所的电力103通信测试的源代码,主要用在工控行业(103 for electricity substation communications test source code, mainly used in the industrial sector)
    2013-07-06 09:23:40下载
    积分:1
  • 5
    说明:  5. 在三条径的瑞利信道中,对于直接序列扩频: (1) 请设计DS-CDMA一种具体的码分导引辅助的信道估计方法,接收机分别采用等均益合并、最大比合并。用Simulink进行仿真,画出比特信噪比与信道估计均方误差的关系曲线和比特信噪比与误码率的关系曲线。 (2) 设频率已经同步,请设计DS-CDMA一种具体的单停顿滑动相关时间同步方法,用Simulink进行仿真,画出比特信噪比与捕获概率的关系曲线。 (3) 设时间已经同步,请设计DS-CDMA一种具体的频率同步方法,用Simulink进行仿真,画出比特信噪比与频率同步误差的关系曲线。(5. In three-path Rayleigh channel, for direct sequence spread spectrum: (1) please design a specific code division navigation aided channel estimation method for ds-cdma, and adopt equal-beneficial combination and maximum ratio combination for receivers respectively.Simulink is used to simulate and draw the relationship curve between bit SNR and channel estimation mean square error and the relationship curve between bit SNR and bit error rate. (2) assuming that the frequency has been synchronized, please design a specific single-stop sliding correlation time synchronization method ds-cdma, Simulink simulation, draw the relationship between the bit SNR and the acquisition probability curve. (3) if the time has been synchronized, please design a specific frequency synchronization method ds-cdma, Simulink simulation, draw the relationship between the bit SNR and frequency synchronization error curve.)
    2019-01-15 10:58:23下载
    积分:1
  • hippe-vector-pattern
    vfev ve vvevfevefvevvevefve
    2018-12-17 04:06:39下载
    积分:1
  • Digital-Communications-Proakis-Solution-Manual
    Digital Communication Solutions Vol 4
    2013-05-06 15:28:07下载
    积分:1
  • 254387
    说明:  服从瑞丽分布的多普勒频移的MATLAB仿真经典(MATLAB Simulation Classic of Doppler Frequency shift following Rayleigh Distribution)
    2019-03-28 03:43:27下载
    积分:1
  • 696518资源总数
  • 104269会员总数
  • 42今日下载