登录
首页 » matlab » pca-pcr

pca-pcr

于 2021-01-04 发布 文件大小:1KB
0 112
下载积分: 1 下载次数: 45

代码说明:

  主元分析与主元回归用于函数的回归拟合已测试(Principal component analysis and principal component regression regression fit for function)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Cal_E_Field_Dipole
    Calculate E-field of dipole antenna.
    2009-03-15 09:13:39下载
    积分:1
  • convex_round-hole
    convex_round-hole 光波透过圆孔模拟透镜成像效果(convex_round-hole wave through the hole simulation results lens imaging)
    2006-12-08 23:17:46下载
    积分:1
  • Spectrum_18363_Sep_2013
    ieee spectrum 2013 september
    2014-11-21 20:02:09下载
    积分:1
  • arithmetic_FastICA
    Matlab环境下的基于独立分量分析(ICA)算法,信号处理,非常重要!-(Matlab environment based on the independent component analysis (ICA) algorithm, signal disposal , very important!)
    2009-11-28 13:15:18下载
    积分:1
  • MATLAB7_0_learning
    说明:  有关MATLAB的学习资料,清华大学出版的(MATLAB information about the study, published by Tsinghua University)
    2010-04-28 23:17:22下载
    积分:1
  • ecgdetect
    说明:  ecg信号检测程序。非常好用!!!ecg信号检测程序。非常好用!!!(ecg detection program---very good,ecg detection program---very good,ecg detection program---very good,ecg detection program---very good,)
    2010-04-14 22:13:48下载
    积分:1
  • quchumaoci
    基于静脉细化的基础上,判断是否为分叉点或者节点,去除静脉中毛刺。(Refinement based on the basis of vein, to determine whether the bifurcation point, or node, remove the veins in the burr.)
    2010-05-23 16:24:22下载
    积分:1
  • GA-opf
    利用遗传算法解决电力系统最优潮流问题。程序opf1为最优潮流的模型建立部分,gaopf是主函数,求解最小燃料费用。(By using the genetic algorithm to solve the power system optimal power flow problem.Program opf1 for optimal power flow model is established in this part, gaopf is the main function, and solving the minimum fuel costs.)
    2021-03-23 19:49:15下载
    积分:1
  • IEEE_RWEP_Project85
    IEEE Papers on power electronivs Dec
    2015-01-15 08:21:34下载
    积分:1
  • Voltage sags are one of the main problems
    Voltage sags are one of the main problems in transmission and distribution grids with high penetration of distributed generation. This paper proposes a voltage support control scheme for grid-connected power sources under voltage sags. The control is based on the injection of reactive current with a variable ratio between positive and negative sequences. The controller determines, also, the amount of reactive power needed to restore the dropped voltage magnitudes to new reference values confined within the continuous operation limits required in grid codes. These reference values are chosen in order to guarantee low current injection when fulfilling the voltage support objective. Selected experimental results are reported in order to validate the effectiveness of the proposed control.
    2014-04-17 21:22:47下载
    积分:1
  • 696518资源总数
  • 104228会员总数
  • 45今日下载