-
CAN-RS232
基于51控制的CAN 转RS232整理程序(Based on 51 control CAN turn RS232 sorting procedure)
- 2014-10-25 10:10:20下载
- 积分：1
-
数字电压表%28ADC0809%29-2
说明： 这是一款数字电压表，ad转换之后显示出来，一个简单的例程(For robots, most of the information is obtained from
visual sensors and tactile sensors (including slide
tactile sensor). The visibility in the seawater of China
is very low except Nanhai. Even in the water of high
visibility, the water will be turbid and the visibility
will become very low when the robot is working.)
- 2019-05-03 22:02:13下载
- 积分：1
-
pid
基于传统PID的直流电机双环控制系统仿真，已验证通过(DC motor based on the traditional PID loop control system simulation, has been verified through)
- 2013-08-12 16:10:05下载
- 积分：1
-
2610IO
dmc2610运动控制卡编写IO输出，对想编写运动控制的人有非常大的帮组(the dmc2610 motion control card write IO output, very large help group for people who want to write the motion control)
- 2020-09-10 05:08:03下载
- 积分：1
-
crc16_oneself
crc校验程序，采样MEGA32单片机，可以设置为查表或者计算方式(crc check program, sampling MEGA32 microcontroller, can be set to look-up table or formula)
- 2010-08-24 10:10:21下载
- 积分：1
-
STC12C5A60S2_AD
STC12C5A60S2的8路10位AD转换程序，本人亲自写的，绝对好用。(8 10-bit AD conversion process in STC12C5A60S2 , personally written , absolutely easy to use .
)
- 2012-02-22 15:29:32下载
- 积分：1
-
emWIN5.12中文手册
说明： emWIN5.12中文手册，不是最新版本，但大部分函数都在(EMWIN 5.12 Chinese manual, not the latest version, but most functions are in)
- 2020-03-30 00:11:32下载
- 积分：1
-
kleeman_kalman_basics
1. Provide a basic understanding of Kalman Filtering and assumptions
behind its implementation.
2. Limit (but cannot avoid) mathematical treatment to broaden appeal.
3. Provide some practicalities and examples of implementation.
4. Provide C++ software overview.
- 2015-01-26 11:14:27下载
- 积分：1
-
fw_dspin_stm32
基于STM32的DSPIC芯片的步进电机驱动，意法官方库。(DSPIC based on the STM32 chip stepper motor driver, STMicroelectronics official repository.)
- 2014-03-07 20:12:23下载
- 积分：1
-
Infrared-alarm-system
本论文设计了由AT89C52单片机为控制核心,用红外线为监测装置的防盗报警系统。该系统中红外对管作为红外线的发射和接收部分。发射部分采用红外发光二极管，而使用光敏三极管作为接收部分，接收红外发光二极管发出的红外线（不可见光）。单片机将通过内部的软件系统检测到接收管的导通或截止状态,并根据检测到的信号状态,进行判断并输出报警信号, 直至按复位按钮或电源开关。声光报警信号由9014三极管驱动构成声光报警电路,进行声光同时报警。电源部分采用变压器将220V交流市经变压器降压，桥式整流器整流，电解电容滤波，三端稳压管78L05稳压，最后得到整机要求的+5V稳定直流电源。实验表明，本系统成功运行。(This thesis is designed by AT89C52 microcontroller as the control center for monitoring device with infrared burglar alarm system. The system of infrared tube as infrared transmitting and receiving section. Emitting portion using infrared light emitting diode, a phototransistor as a receiving portion to receive the infrared ray emitted from the infrared light emitting diodes (not visible). The microcontroller will be detected by the internal software system to the turned on or off state of the receiver tube, and according to the detected signal state, to determine and output an alarm signal until a reset button or the power switch. Audible and visual alarm signal by 9014 transistor drive constitute sound and light alarm circuit, sound and light alarm at the same time. The power part of the transformer 220V AC City by the step-down transformer, bridge rectifier rectifier, electrolytic capacitor filter, three-terminal regulator 78L05 regulator, and finally get the machine requirements+5V)
- 2012-10-08 14:35:19下载
- 积分：1
