-
SPIHTsuanfashixian
利用MATLAB实现的SPIHT算法源代码
MATLAB实现的SPIHT算法源代码(SPIHT algorithm implemented using MATLAB source code MATLAB implementation of the SPIHT algorithm source code)
- 2010-05-15 16:44:18下载
- 积分：1
-
SAR_simulation
SAR雷达成像仿真 基于MATLAB的三种不同的算法程序 分析频谱与分辨率(SAR radar imaging simulation based on MATLAB for three different algorithms of spectrum and resolution procedures)
- 2010-09-17 10:05:22下载
- 积分：1
-
SEGMENT
对一幅图像使用最大类间分割算法，对其惊醒分割处理，得到二值图像(The segmentation algorithm between categories
)
- 2013-05-13 19:44:16下载
- 积分：1
-
2004_5337
Particle Filtering for Sequential Spacecraft Attitude Estimation
卫星姿态估计的另外一种粒子滤波的介绍(Particle Filtering for Sequential Spacecraft Attitude Estimation for Satellite Attitude estimated another particle filter introduction)
- 2007-12-20 11:35:26下载
- 积分：1
-
RS_BCH
用matlab实现BCH和RS码的译码的仿真(Using matlab to achieve decoding BCH and RS Simulation)
- 2010-10-05 21:00:06下载
- 积分：1
-
Newton_interplotion
说明： 牛顿插值的MATLAB程序。需要的来下载。(Newton interpolation process of MATLAB. Need to download.)
- 2009-08-02 00:07:21下载
- 积分：1
-
Fuzzy-control-system-design
基于matlab的工具箱，应用模糊控制系统方法设计实现PID控制。(Based on Matlab toolbox, the application of fuzzy control system design method achieves the PID control.)
- 2012-06-02 22:14:48下载
- 积分：1
-
elastic_cerjan
均匀介质各向同性二维弹性波数值模拟，采用cerjan边界条件。有公式及参考文献。带有速度模型以及雷克子波函数，解压后直接运行就可以。(The homogeneous medium isotropic two-dimensional elastic wave numerical simulation, using cerjan boundary conditions. formulas and references Sample are added.With the velocity model and the the Ricker wave function, and can be run directly after decompression.)
- 2012-09-08 15:13:11下载
- 积分：1
-
matlab
编写M文件，创建如下图形窗口，分别绘制如下图所示的曲线。
（1）曲线y=sin(t)sin(9t)，要求采用红色，点线。横坐标取值范围[0~ ]，标注x轴、y轴并加标题。
（2）一组余弦曲线，其振幅分别为0.4，0.6和0.8。横坐标取值范围[0~2 ]。添加图例与标题。进入图形编辑状态，调整图例的位置。
（3）分别绘制peaks函数的曲面图和网格线图。对曲面图做平滑处理，并添加标题与colorbar。
(Write M file, create the following graphics window, curves were plotted as shown below. (A) the curve y = sin (t) sin (9t), require the use of a red dotted line. The abscissa in the range [0 ~ ], labeled x-axis, y-axis and a title. (2) a set of a cosine curve, and the amplitude was 0.4, 0.6, 0.8. Abscissa value range [0 ~ 2 ]. Add a legend and title. Into the graphical editing mode, adjust the position of the legend. (3) were drawn surface chart peaks function and grid line graph. Surface charts do for smoothing and add titles and colorbar.)
- 2013-12-24 12:19:01下载
- 积分：1
-
lfsr
1）利用CC++语言实现给定的LFSR；
2）通过不同初始状态生成相应的序列，并观察它们的周期有什么特点；
3）利用生成的序列对文本进行加/解密（按对应位作模2加运算）。
给定的LFSR为：(1) the use of C C++ language given LFSR
2) to generate the corresponding sequences by different initial state, and observe what are the characteristics of their cycle
3) using the generated sequence of text encryption/decryption (press the corresponding bit for modulo-2 addition operation).
LFSR given as follows:)
- 2015-12-14 16:26:56下载
- 积分：1
