-
MAT_demo
MAT-file importer to C++ with and without binds to matread/write library functions
- 2008-06-03 02:07:50下载
- 积分：1
-
watermark
说明： 基于DCT变换的数字水印实现，实现可数字水印的嵌入和提取，是MATLAB7.0环境下开发的( Itisa )
- 2010-04-03 16:52:46下载
- 积分：1
-
without_dc
用matlab仿真模糊控制器，有一定的帮助(fuzzy controller)
- 2009-05-08 12:39:05下载
- 积分：1
-
parameter_classic
在MATLAB环境下用经典参数法求高斯信道的参数(In the MATLAB environment parameters method with the classical Gaussian channel parameters)
- 2009-05-31 13:25:16下载
- 积分：1
-
IM
simulation of three phase induction motor in matlab simulink
- 2013-05-12 04:38:42下载
- 积分：1
-
DC-AC
逆变器仿真程序,模拟AC-DC，需要者可以参考(Inverter simulation, simulation of AC- DC, those can be reference
)
- 2014-08-11 13:03:27下载
- 积分：1
-
grd_test
xwch_test.m是主测试文件；biaoji.mat存放滤波器系数；xiangweicha.m用FFT计算相位差。
仿真框架为：
1.标记信号和双音信号续接作为发送信号；
2.对双音中一个频率分量的相位做偏移，再经过一个低通滤波器（引入线性相位，模拟收发不能同步测量现象）后，作为收到的信号；
3.用一个检测信号对收发信号进行相关运算；
4.画出收发信号以及相关处理后的信号。找出相关信号的那个尖点，从而推算出收发双音信号0相位点；
5. 输入0相位点位置，计算相对相位差。(xwch_test.m is the main test file biaoji.mat store filter coefficients xiangweicha.m calculated using FFT phase difference. Simulation framework: 1. Mark signals and then as a two-tone signal continued to send signals 2. On a two-tone frequency components of the phase shift to do, and then through a low pass filter (the introduction of linear phase, simulation can not simultaneously send and receive measuring the phenomenon), the as received signal 3. using a detection signal of the transceiver signal correlation operation 4. draw send and receive signals and related processed signal. Correlated signal of the cusp, which calculate the two-tone signal transceiver 0 phase point 5. Enter 0 phase point position, calculate the relative phase difference.)
- 2010-06-12 17:31:00下载
- 积分：1
-
Frame-seg
Frame segmantation in matlab
- 2011-01-24 13:21:07下载
- 积分：1
-
PAPR
ofdm的 papr 降低 适合初学者的程序
- 2011-07-03 15:36:12下载
- 积分：1
-
Doc1
this is new approach for fuel cell control.it is really helpfull.
- 2013-09-09 17:12:27下载
- 积分：1
