-
PDAF
实现了跟踪中的概率互联算法（PDAF），模型采取匀速直线模型。(Probability in the track association algorithm (PDAF), the model to take the uniform linear model.)
- 2012-03-28 00:17:01下载
- 积分：1
-
CODEProgram27_FDTD_2D_with_Mur_ABC_boundary
2D FDTD of a region with Mur s absorbing boundary
- 2012-06-02 15:22:09下载
- 积分：1
-
fft
全球导航系统中，软件接收机基带处理部分的捕获电路的算法仿真(FFT acquisition )
- 2013-03-28 10:17:48下载
- 积分：1
-
qw
对最小相位系统的性能研究以及DMC的仿真实例。(The simulation study of the performance of the system and the minimum phase of DMC.)
- 2013-12-27 17:25:11下载
- 积分：1
-
LABVIEW(WAVELET)
修改后的LABVIEW小波（调用MATLAB）(LABVIEW modified wavelet (call MATLAB))
- 2008-12-23 11:39:40下载
- 积分：1
-
foreasting
这是一个有预测功能的程序，还没有进行优化，可供大家作为基础来加以改进，但是大概的预测方向都是准确的(This is a prediction function of the procedure have not yet optimized for the U.S. used as the basis to be improved, but perhaps the direction of the prediction is accurate)
- 2009-03-14 14:10:33下载
- 积分：1
-
IEEE30
30节点的潮流计算程序，输电网的，这个可以运行(Flow calculation nodes 30, transmission network, this can run)
- 2016-03-19 10:29:53下载
- 积分：1
-
t5_zhihuan
说明： 电流滞环跟踪(CHBPWM)控制技术在simulink上的仿真(Simulation of current hysteresis tracking (chbpwm) control technology on Simulink)
- 2020-05-17 23:18:54下载
- 积分：1
-
chengxu
小波变换进行变速箱故障诊断
首先将s1和s2信号时域谱（s1代表维修前的振动信号，s2代表维修后的振动信号），画出来进行对比，会发现s1信号的振动幅值会比较高；然后对s1和s2分别进行小波分解并画出各层的时域谱，只对比s1和s2分后的最高时域谱，s2更加的具有周期性，且幅值较小，s2周期性不够明显，且振动过于密集。分析完时域谱后开始分析频谱，首先对原信号s1和s2fft转换，得到频谱图，如图，然后再对小波分析后高频部分进行fft转换，做出频谱图。对比后我们发现，在f 2375HZ出（也就是齿轮的啮合频率），s1信号频谱幅值会有急剧的升高，然后，其谐波的幅值也会增大。所以可以推断出该维修前的增速箱的齿轮可能出现问题。(Gearbox fault diagnosis based on wavelet transform s1 and s2 first time domain signal spectrum (s1 behalf of the vibration signal before maintenance, vibration signal s2 representative of repaired), drawn comparison, you will find a signal s1 vibration amplitude will be higher then s1 and s2 respectively wavelet decomposition and draw the layers of time-domain spectrum to only a maximum time domain spectroscopy s1 and s2 points after, s2 is more cyclical and smaller magnitude, s2 cyclical enough obviously, and the vibration is too dense. End domain spectral analysis after the beginning of the spectrum analysis, the first of the original signal s1 and s2fft conversion to give the spectrum, as shown, and then after the high frequency part of wavelet analysis fft transformation to make spectrum. We found that after the comparison, at f 2375HZ out (i.e. the gear mesh frequency), there will be a sharp increase in the amplitude spectrum of the signal s1, and then, the amplitude of the ha)
- 2017-01-17 19:18:02下载
- 积分：1
-
fuzzy4
基于模糊控制的避障导航算法，MATLAB平台图形化仿真(Obstacle avoidance navigation algorithm based on fuzzy control, graphical simulation of MATLAB platform)
- 2017-10-14 20:37:33下载
- 积分：1
