登录
首页 » PDF » 2010-WinBis[1]

2010-WinBis[1]

于 2013-12-30 发布 文件大小:492KB
0 86
下载积分: 1 下载次数: 4

代码说明:

  Performance Assessment of Congestion Control Transport Protocols for Wireless Sensor Networks

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Steppingmotor
    此源码为c#编写的pc上位机程序,通过串口实现对3路步进电机的控制,可选择电机使能,正反转,转动角度,细分数等(This source code is written in c# program pc PC through the serial interface on the 3-way stepping motor control, motor option is enabled, rotating, rotation angle, and number of segments)
    2010-08-19 10:34:29下载
    积分:1
  • MRAM
    强力向各位推荐一种比铁电存储器更优越的存储器-磁电存储器,集各种存储器优点于一体,很好的文章。(Strongly recommend to you a superior than the FRAM memory- magnetic memory, set in one of the advantages of various storage, very good article.)
    2011-06-14 23:31:29下载
    积分:1
  • triangle
    由单片机和DAC0832产生正弦波或三角波的程序。单片机和DAC0832可将频率进行分频的具体程序(Sine or triangle wave and DAC0832 procedures generated by the microcontroller. SCM and DAC0832 can divide the frequency of specific procedures)
    2014-01-11 15:53:32下载
    积分:1
  • u盘
    stm32-usb+nandflash+sd=u盘 ,用stm32+nandflash模拟u盘,使用的是fatfs文件系统,电脑格式化后,即可当u盘使用了。(Stm32-usb+nandflash+sd=u disk, use stm32+nandflash to simulate u disk, use fatfs file system, after the computer is formatted, it can be used as u disk.)
    2020-11-11 16:09:45下载
    积分:1
  • blmsensor
    通过comm口,读取外部压力或温度传感器的数据,并显示在界面上(Comm port by reading data the external pressure or temperature sensor, and displayed on the screen)
    2014-10-13 15:07:28下载
    积分:1
  • step
    说明:  用proteus仿真实现BLDC无刷直流电机的控制,目前仅工作于开环状态,可以参考一下。(BLDC brushless DC motor control is realized by Proteus simulation. At present, BLDC brushless DC motor only works in open-loop state, which can be referred to.)
    2019-07-10 15:01:55下载
    积分:1
  • V0.41
    说明:  foc,svpwm,无刷无感电机驱动方案(FOC /SVPWM,brushless induction motor drive scheme)
    2021-04-27 13:28:44下载
    积分:1
  • RTD2660_AV1_AV2_081015
    这是TV/液晶显示的源代码.(RTD2660)(This is the TV/LCD source code. (RTD2660))
    2010-05-25 13:02:36下载
    积分:1
  • a
    说明:  设计一个VI来测量温度(保留2位小数),每隔0.25秒测一次,共测定10秒。在数据采集过程中,VI将在波形Chart上实时地显示测量结果。采集过程结束后,在Graph上画出温度数据曲线,并且把测量的温度值以文件的形式存盘, 使用记事本打开文件检查结果是否正确。 存盘格式为: 点数 时间(S) 温度值(度) 1 0.25 78.56 2 0.50 85.32(Design a VI to measure the temperature (keep two decimal places), measured once every 0.25 seconds, 10 seconds were measured. In the data collection process, VI will display the measurement results in real time on the waveform Chart. After the acquisition process, the temperature data in the Graph draw curves, and the temperature measured in the form of document archiving, Use Notepad to open the file to check the result is correct. Save format: Points Time (S) temperature (degrees) &nbsp 1 0.25 78.56 &nbsp 2 0.50 85.32)
    2014-04-16 12:24:25下载
    积分:1
  • Automatic-control-precision-of-SDT-algorithm
    Automatic control precision of SDT algorithm
    2012-09-11 15:26:04下载
    积分:1
  • 696518资源总数
  • 104353会员总数
  • 66今日下载