登录
首页 » matlab » Cumulant-Based-Inverse-Filter

Cumulant-Based-Inverse-Filter

于 2014-02-20 发布 文件大小:438KB
0 60
下载积分: 1 下载次数: 3

代码说明:

  Cumulant-Based Inverse Filter

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • algorytmy-eksploracji
    bayes code for matlab
    2011-01-19 22:33:22下载
    积分:1
  • JPDAF
    进行多目标跟踪的matlab程序,单传感器,两个目标的JPDAF算法(Matlab program used for multitarget tracking ,single sensor,two target JPDAF algorithm)
    2013-08-07 19:45:15下载
    积分:1
  • pll_sim
    这是一个根据锁相环原理编写的MATLAB仿真程序,内有详细注释,同时附带了仿真结果图。(It is MATLAB simulation program of phase locked loop,while with the simulation results Fig.)
    2010-08-02 11:07:28下载
    积分:1
  • matlab
    matlab lagran.m 拉格朗日插值 divDiff 牛顿差商表(matlab lagran.m divDiff.m)
    2009-10-03 09:36:13下载
    积分:1
  • IFsignal
    matlab模拟把RF信号和LO信号输入到mixer里得到IF信号。(simulate for put the LO signal and the RF signal into the mixer to get the IF signal.)
    2013-10-20 12:48:20下载
    积分:1
  • functionz1
    说明:  寻找三次样条多项式需要求解大量的线性方程。实际上,给定N个断点,就要寻找N-1个三次多项式,每个多项式有4个未知系数。这样,所求解的方程组包含有4*(N-1)个未知数。把每个三次多项式列成特殊形式,并且运用各种约束,通过求解N个具有N个未知系数的方程组,就能确定三次多项式。 (find cubic spline solving polynomial need a lot of linear equations. In fact, given N breakpoints, it is necessary to look for N-1 cubic polynomial, each with four polynomial coefficients unknown. Thus, by solving the equations contain 4* (N-1) unknown. Each cubic polynomial Timing special form, and use of various constraints, by solving N with N unknown coefficient equations, we can identify three polynomial.)
    2006-03-15 21:22:27下载
    积分:1
  • DTALK
    说明:  结合回声消除和语音增强方法的double talk算法,能在噪声环境下定出语音的端点(light echo cancellation and voice enhancement method of double talk algorithm can be noisy environment set voice endpoint)
    2006-03-21 16:24:55下载
    积分:1
  • ejdlb
    用s函数写得二级倒立摆模型,用状态反馈、最优控制、模糊控制进行仿真。(S function written with double inverted pendulum model, using state feedback, optimal control, fuzzy control simulation.)
    2009-06-08 19:10:18下载
    积分:1
  • matlab3
    利用matlab编程求解实现拓扑优化的源代码及程序界面设计,采用三角形网格划分!我的毕业设计!(Programming using matlab to solve topology optimization to achieve the source code and procedures for interface design, using triangular meshing! My graduation!)
    2010-03-13 02:05:59下载
    积分:1
  • nonnegativeICAexample
    非负独立分量盲源信号的分离方法是一种很简单的盲源分离方法(Non-negative independent component blind source separation method is a very simple blind source separation methods)
    2013-10-30 11:05:47下载
    积分:1
  • 696518资源总数
  • 104269会员总数
  • 42今日下载