登录
首页 » matlab » COS207_MATLAB1

COS207_MATLAB1

于 2010-08-10 发布 文件大小:3KB
0 88
下载积分: 1 下载次数: 1

代码说明:

  移动无线信道COS207模型MATLAB程序,对做信道仿真的朋友有参考价值(Mobile radio channel model MATLAB COS207 procedures, channel simulation of a friend doing a valuable reference)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • medianfilter
    design of median filter to remove noise
    2010-10-16 13:04:11下载
    积分:1
  • MiniProject
    exercise for fuzzy inference engine
    2010-12-24 16:46:03下载
    积分:1
  • tridiagonal
    solve a system of linear equations
    2012-04-26 15:19:36下载
    积分:1
  • FSADA
    旋转Y切-弹性压电薄膜,谐振器的特性计算及分析,用MATLAB编程计算。(Rotated Y-cut- elastic piezoelectric thin film resonator characteristic calculation and analysis, calculated using MATLAB programming.)
    2013-12-02 09:53:27下载
    积分:1
  • matlab
    matlab通信仿真与应用(详细),是一套比较好的关于通信仿真书籍(matlab simulation and application of communication (in detail), is a relatively good simulation of books on communication)
    2008-02-21 11:57:08下载
    积分:1
  • GMSK
    基于MATLAB的GMSK基带解调器的设计与实现,使用SIMULINK进行仿真和应用
    2009-05-12 12:14:49下载
    积分:1
  • tongyuan1
    常用的数字PAM信号波形及其功率谱的仿真,包含源码和一份实验报告,有详细的分析。(Commonly used in digital PAM signal waveforms and power spectrum of the simulation, including source code and a test report, detailed analysis.)
    2009-06-28 11:29:13下载
    积分:1
  • rwave
    algorithm to find stock price wave when using positive return rate as wave condition.For example, find the S&P500 index whole waves, whose change rate is more than 5 from bottom to top.
    2013-08-26 12:19:11下载
    积分:1
  • KPCA1
    改程序为基于核函数的主成分分析算法的MATLAB实现程序,对于学习KPCA有很大帮助(This program is the MATLAB program which is based on the kernel principal component analysis )
    2013-03-20 21:47:17下载
    积分:1
  • eee
    杨氏双缝干涉 两相干光源到接收屏上P点距离r1=(D2+(y-a/2)2)1/2, r2=(D2+(y+a/2)2)1/2, 满足相干条件的光波叠加后,对于观察屏上某一确定点,即r1、r2确定后,叠加后的光强为 式中λ为光波的波长, 、 ,令相位差φ=2π(r2-r1)/λ, 最后可得公式如下: , 最后光强I=4I0cos2(Φ/2)。 观察相干光叠加后光强的分布. (Young' s double slit interference two coherent light source to the point P on the receiving screen distance r1 = (D2+ (YA/2) 2) 1/2, r2 = (D2+ (y+a/2) 2) 1/2, meet coherent conditions lightwave after superposition, for a determined point on the viewing screen, i.e. R1, R2 is determined, the superimposed light intensity where λ is the wavelength of light, make the phase difference φ = 2π (R2-R1)/λ, final can be obtained using the following formula: Finally, the light intensity I = 4I0cos2 (φ/2). Observed coherent superposition of light intensity distribution.)
    2013-01-03 21:04:13下载
    积分:1
  • 696518资源总数
  • 104269会员总数
  • 42今日下载