-
Comparison of Gyroscope
Comparison of Gyroscope
- 2018-08-22 17:55:59下载
- 积分：1
-
ADC
c8051F060中adc部分程序,是对adc部分的使用说明以及参考(Part of the ADC program in c8051F060)
- 2015-03-06 18:36:47下载
- 积分：1
-
FreeRTOS实验15-1 FreeRTOS软件定时器实验
说明： 硬件资源:
1,DS0(连接在PA8)，DS1(连接在PD2上)
2,串口1(波特率:115200,PA9/PA10连接在板载USB转串口芯片CH340上面)
3,ALIENTEK 2.8/3.5/4.3寸LCD模块(仅支持MCU屏)
4,按键KEY0(PC5)/KEY1(PA15)/KEY_UP(PA0,也称之为WK_UP)
实验现象:
通过按键KEY_UP可以控制定时器AutoReloadTimer_Handle的开启，这个是
周期定时器，一旦开启就会不断的运行，直到按下KEY1将其关闭。按下KEY0
可以打开定时器OneShotTimer_Handle，这是个单次定时器，只会运行一次，
运行周期到了以后就会停止运行，除非按下按键KEY0将其再次开启。(Hardware resources:
1, DS0 (connected to PA8), DS1 (connected to PD2)
2. Serial port 1 (baud rate: 115200, PA9/PA10 connected on board USB to serial chip CH340)
3, ALIENTEK 2.8/3.5/4.3 inch LCD module (only supporting MCU screen)
4. Keyboard KEY0 (PC5)/KEY1 (PA15)/KEY_UP (PA0, also known as WK_UP)
Experimental phenomena:
The timer AutoReloadTimer_Handle can be turned on by keying KEY_UP. This is
The periodic timer will run continuously once it is turned on until KEY1 is pressed to turn it off. Press KEY0
You can turn on the timer OneShotTimer_Handle, which is a single timer and only runs once.
The run cycle will stop after that unless KEY0 is pressed to turn it on again.)
- 2020-06-24 05:00:01下载
- 积分：1
-
ewarm-6.40.5-project-with-crc32-and-start-value
CRC32 source code for IAR workbench
- 2016-10-21 11:16:42下载
- 积分：1
-
SOC_SMO_Battety
说明： 电池SOC估算模型,是MATLAB中的simulink仿真模型，可以估算电池SOC(Battery SOC Estimation Model)
- 2021-03-07 23:49:29下载
- 积分：1
-
8051_timer
this is 8051 microcontroller timer code
- 2016-02-04 12:06:32下载
- 积分：1
-
ADI-reference_design_15chbmu_201312
ADI公司锂电池包智能电池管理BMS参考设计方案(Referrence design for BMS of LI-ON batttery pack)
- 2014-01-14 14:19:31下载
- 积分：1
-
bh1750程序
说明： 通过bh1750与stm32连接，检测光照强度并显示在液晶屏(Through the connection of bh1750 and STM32, the light intensity is detected and displayed on the LCD screen)
- 2020-05-27 03:02:36下载
- 积分：1
-
Profibus
基于STM32单片机的profibus-dp的软件通信协议的实现(Design of profibus-DP software protocol based on STM32 MCU)
- 2021-05-14 00:30:02下载
- 积分：1
-
ADC1_TriggerConversion
根据对应的按键值，对应输出相应的电容值，并做掉电检测(According to the corresponding key value, corresponding to the output of the corresponding capacitance values and do brownout detection)
- 2013-11-26 23:42:16下载
- 积分：1
