-
FTCP动态库
FTCP动态库是使用C++语言编写的可以实现与DTU交互的工具包(The FTCP dynamic library is a toolkit that uses the C++ language to interact with DTU)
- 2018-02-09 08:58:01下载
- 积分：1
-
Spectrum-analyzer
Useful modding - a spectrum analyzer + clock.
We came across two 5x8 LED matrix, virtually occupying five-inch drive bay, and I decided to make a spectrum analyzer based on their sound.
- 2016-02-16 03:02:42下载
- 积分：1
-
CANtest
CAN test测试功能软件,帮助快速开发产品(CAN test测试功能软件)
- 2014-11-07 09:47:48下载
- 积分：1
-
suoxianghaun
飞思卡尔单片机锁相环程序，详细说明了锁相环的配置步骤以及计算方法(Freescale MCU PLL procedures, a detailed description of the PLL configuration steps and calculation methods)
- 2020-11-09 21:29:46下载
- 积分：1
-
Automatic-traffic-control-system-
自动交通控制系统用红、绿、黄三支共两组发光二极管表示交通信号灯，利用单片机模拟有时间显示的定时交通信号灯控制管理。信号灯的变化规律可如下：
1）放行线：绿灯亮放行25秒，黄灯亮警告5秒，然后红灯亮禁止。
2）禁示线：红灯亮禁止30秒，然后绿灯亮放行。
3）当某一方向的红灯亮时，若该方向有车通过，则用扬声器声报警。（撞红灯信号可用3-5V模拟量表示）(Automatic traffic control system using red, green, yellow light-emitting diodes, said a total of three traffic lights, the use of single-chip analog time display on a regular traffic signal control and management. Changes of lights to be as follows: 1) Release Line: green clearance 25 seconds, the yellow light warning for 5 seconds, then the red light is prohibited. 2) ban shows lines: the red light is prohibited for 30 seconds, then the green light to release. 3) When the red light in one direction, if the direction of the car through, the alarm speaker sound. (Hit the red signal available 3-5V analog representation))
- 2013-12-19 18:26:11下载
- 积分：1
-
Demo
说明： 周立功EASYarm板所带出厂程序，包含按键，LED，蜂鸣器，AD转换的代码(ZLG EASYarm board brought the factory process, including buttons, LED, buzzer, AD conversion code)
- 2010-04-15 10:47:34下载
- 积分：1
-
222009322072112
由于太阳能充电系统多在户外，为了方便研究太阳能充电控制系统对蓄电池的充电情况，本文使用GPRS无线传输技术，设计了一套太阳能充电系统蓄电池的充电电压电流远程实时监测系统。系统的硬件部分由电压电流检测电路、单片机STC89C52RC、GPRS模块SIM300以及相应的外围电路构成，下位机软件由C语言编写并与硬件部分构成系统下位机部份，实现了对充电电压电流的信息采集以及数据的无线数传。上位机在LabVIEW2010环境下编写，具备友好的人机交互界面，实现了数据的远程接收、实时显示、数据库管理、报表生成和打印等功能。经过系统测试系统实现了对电压电流的远程监测。(As the solar charging system more outdoors, in order to facilitate the study of solar charge control system for charging the battery case, we use GPRS wireless transmission technology, we designed a solar charging system battery charge voltage and current remote monitoring system. The hardware part of the system by the voltage and current detecting circuit, microcontroller STC89C52RC, GPRS module SIM300 and corresponding peripheral circuits, lower computer software written in C language and hardware parts lower position machine part of the system, the realization of the charging voltage and current information collection and wireless data transmission of data. PC at LabVIEW2010 prepared environment, with friendly interactive interface, realize the remote receiving data, real-time display, management, report generation and printing. After the system test system enables remote monitoring of voltage and current.)
- 2016-01-08 11:43:43下载
- 积分：1
-
analog-I2C-driver-MPU050
stm32芯片--用GPIO口模拟I2C驱动MPU6050陀螺仪(Stm32 chip- using GPIO port simulation I2C driver MPU6050 gyroscope)
- 2013-12-19 19:43:04下载
- 积分：1
-
cPP
Richard Kaiser
C++ mit
Microsoft Visual C++ 2008
- 2013-12-12 20:42:59下载
- 积分：1
-
111
步进电机驱动，微处理器为S3C2410，具有调节转速功能(Stepper motor drive, microprocessor S3C2410, adjust the speed function with)
- 2011-05-21 21:36:05下载
- 积分：1
