登录
首页 » matlab » BPNN

BPNN

于 2015-03-19 发布 文件大小:10KB
0 124
下载积分: 1 下载次数: 11

代码说明:

  反向传播神经网络的学习算法以及MATLAB实现代码(Back propagation neural network learning algorithm and MATLAB code)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 2ASK
    幅度调制解调:用两种方法实现解调包络检波和相干(Amplitude modulation and demodulation: two ways to achieve envelope demodulation and coherent demodulation)
    2008-03-31 14:18:13下载
    积分:1
  • The-calculation-method
    随着计算机的迅速发展与广泛运用,在众多的领域,科学计算方法的应用越来越广泛了,而MATLAB在进行科学计算方面有着无与伦比的优势。本章介绍MATLAB在计算方法中的运用。(With the rapid development of the computer and widely used in many areas, scientific computing method used more widely, and MATLAB in scientific computing has the advantage of incomparable. This chapter introduces the application of MATLAB calculation method.)
    2012-04-17 17:14:34下载
    积分:1
  • RADARSimulation
    雷达仿真的源程序,功能齐全,添加了界面,易于使用。(Radar Simulation of the source, fully functional, add the interface easy to use.)
    2010-11-11 23:53:38下载
    积分:1
  • AlamoutiSchemewithGUI-PerformsMonte-Carlosimulatio
    瑞历信道下误码率估计的盟特卡罗仿真,GUI显示,方便高效(Switzerland calendar channel bit error rate estimated UNITA Carlo simulation, GUI, facilitate efficient)
    2007-01-10 16:37:54下载
    积分:1
  • neidian
    电力系统中进行最优潮流计算时所用的内点法计算最优潮流,此为MATLAB仿真软件所用。(Power system optimal power flow calculation interior point method used to calculate the optimal power flow, this is the MATLAB simulation software.)
    2013-05-13 08:42:12下载
    积分:1
  • compensation-of-dead-time
    交流伺服系统中的死区效应分析与补偿分析了逆变器的死区效应产生的原因及其对交流伺服系统控制性能产生的影响,指出死区补偿的关键 在于电流相位的获取,为了克服实际系统中电流零点的模糊性,提出了一种基于两相静止坐标系下的前馈死 区补偿方法. 该方法通过对三相输出电流一个周期内补偿电压进行傅里叶变换,发现仅需补偿1 ,5 ,7 次谐波 分量即可消除死区效应. 仿真和试验结果验证了这种方法的正确性和可行性.(AC servo system analysis and compensation of dead time effect of the inverter dead time effect causes the impact of the control performance of the AC servo system, and pointed out that the dead time compensation, the key lies in the current phase of the acquisition, in order to overcome the practical zero of the current ambiguity of the system is proposed based on the two-phase stationary coordinate system under the feedforward dead-time compensation method. by the offset voltage of the three-phase output current cycle Fourier transform is found only compensation 1, 5, 7 harmonic components to eliminate the dead time effect. simulation and experimental results verify the correctness and feasibility of this approach.)
    2012-07-21 16:45:42下载
    积分:1
  • COMPENSADOR_EN_ADELANTO_RELOCUS
    Compensator by the method of loci of roots through MATLAB rlocus
    2014-11-05 19:29:47下载
    积分:1
  • Filtro-3-vias
    This is a model of a QPSK modulation system for transmission over a bandpass channel with fc = 100 Hz and B = 30 Hz and AWGN at the receiver. SRRC fi lters with excess bandwidth α = 0.18 are employed. The receiver includes an NDA timing recovery loop followed by a DD phase recovery loop. The transmitter?s symbol period is T and set to a value of 100 ms. The symbol period at the receiver is Tr. The model will produce six windows: Two constellation plots and two eye diagrams (for the real part only), at the output of the matched fi lters and after the recovery loops a plot of the phase error (output of the NCO) and a plot of the fractional timing error (used in the interpolator). The frequency off set at the receiver is denoted by deltaf. The model simulates the transmission of 8000 QPSK symbols.
    2015-02-03 08:10:37下载
    积分:1
  • Energy_detection_simulation
    ENERGY DETECTION OF SIGNAL
    2014-02-16 17:17:34下载
    积分:1
  • krig2d
    二维的克吕金插值,适用于地学类等领域,使用方便(Two-dimensional krig interpolation, applied geosciences)
    2010-08-19 17:21:04下载
    积分:1
  • 696518资源总数
  • 104349会员总数
  • 32今日下载