-
matlabAdjustment
利用ＭＡＴＬＡＢ实现了对测量中的平面网，高程网和边角网的平差，是测量中比不可少的程序．(Realize the use of MATLAB on the measurement plane net, nets and corner elevation adjustment network is the measurement procedures than indispensable.)
- 2007-09-24 10:06:25下载
- 积分：1
-
Lepingle_Ribemont_SDE
随机微分方程数值解！ Numercal Sulution Of Stochastic Differential Equations
By Peter E.Kloeden Eckhard Platen
PC-Exercise 11.4.1
Figure 11.4.1
求解方程 11.4.1(Numercal Sulution Of Stochastic Differential Equations
By Peter E.Kloeden Eckhard Platen
PC-Exercise 11.4.1
Figure 11.4.1
)
- 2011-12-24 09:42:09下载
- 积分：1
-
dipole_coupling
天线原理中,计算偶极子天线不同配置下的互阻抗程序(Antenna theory, computing mutual impedance dipole antenna configuration under different procedures)
- 2021-02-12 10:49:51下载
- 积分：1
-
code
biometric fingerprint recognytion system using gabor features extration
- 2009-07-21 11:39:08下载
- 积分：1
-
delete
CSS in Cognitive Radio
- 2014-11-25 05:21:24下载
- 积分：1
-
001_autoUpgrade
带有版本控制的软件发布升级工具。
带有版本控制的软件发布升级工具。
带有版本控制的软件发布升级工具。
(version control for your software.and aid for your upgrade.version control for your software.and aid for your upgrade.version control for your software.and aid for your upgrade.)
- 2015-02-07 14:54:58下载
- 积分：1
-
matlab
编写M文件，创建如下图形窗口，分别绘制如下图所示的曲线。
（1）曲线y=sin(t)sin(9t)，要求采用红色，点线。横坐标取值范围[0~ ]，标注x轴、y轴并加标题。
（2）一组余弦曲线，其振幅分别为0.4，0.6和0.8。横坐标取值范围[0~2 ]。添加图例与标题。进入图形编辑状态，调整图例的位置。
（3）分别绘制peaks函数的曲面图和网格线图。对曲面图做平滑处理，并添加标题与colorbar。
(Write M file, create the following graphics window, curves were plotted as shown below. (A) the curve y = sin (t) sin (9t), require the use of a red dotted line. The abscissa in the range [0 ~ ], labeled x-axis, y-axis and a title. (2) a set of a cosine curve, and the amplitude was 0.4, 0.6, 0.8. Abscissa value range [0 ~ 2 ]. Add a legend and title. Into the graphical editing mode, adjust the position of the legend. (3) were drawn surface chart peaks function and grid line graph. Surface charts do for smoothing and add titles and colorbar.)
- 2013-12-24 12:19:01下载
- 积分：1
-
fangzhen
用matlab仿真轴承故障信号构造轴承故障的仿真信号，其中轴承的固有频率fn=3000Hz , 位移常数y0=5, 阻尼系数ξ＝0.1, 冲击故障发生的周期为0.01s，采样频率fs=20KHz, 采样点数N=4096。要求：根据上述条件构造轴承故障的仿真信号，画出其时域波形及频谱图。(Matlab simulation bearing fault signal)
- 2021-04-23 21:58:47下载
- 积分：1
-
Speech_Signal_Processing
matlab语音处理信号。直接下载就可用！！！！(matlab voice processing. Directly available! ! ! !)
- 2010-09-13 19:54:03下载
- 积分：1
-
Fassess
二级模糊综合评价（以富营养化评价为例），matlab编写的(Two fuzzy comprehensive evaluation (as eutrophication assessment, for example), matlab prepared)
- 2020-09-11 07:58:00下载
- 积分：1
