-
SAR1
雷达采用匹配滤波完成脉冲压缩，采集频率fs=420MHz,仿真雷达回波，并绘出加Hamming窗前后的脉压波形。目标如图所示由(-5，-2)，(0，5)和(6,-7)三个散射点组成,散射强度分别为（1，2，5）,雷达位于（-5000,0）处(The completion of the radar pulse compression using matched filtering, collecting the frequency fs = 420MHz, simulation of the radar echo, and draw the Hamming window plus post-pulse pressure waveform. Targets as shown by (-5,-2), (0,5) and (6,-7) three scattering dots, scattering intensity, respectively (1,2,5), radar at (-5,000, 0), Office of)
- 2009-12-07 16:35:47下载
- 积分：1
-
3D
说明： 2014-An Analysis and Implementation of a Parallel Ball Pivoting Algorithm
图像3D算法 含源码(2014-An Analysis and Implementation of a Parallel Ball Pivoting Algorithm)
- 2014-09-02 19:03:08下载
- 积分：1
-
flexible-plates
一个关于柔性板的模型降阶与主动控制程序，降阶方法为模态价值分析和内平衡准则，控制方法采用最优控制方法。(A flexible plate on active model reduction and control program, the value of reduced-order method for modal analysis and balancing the standards, control methods using optimal control methods.)
- 2011-11-10 22:36:53下载
- 积分：1
-
FCM-clustering-MATLAB-code
FCM fuzzy c-means clustering algorithm and MATLAB code
- 2015-03-20 09:40:34下载
- 积分：1
-
VCANDMATLAB
VC++与Matlab混合编程之引擎操作详解,对主要函数进行介绍并且有一个实例程序(VC++ and Matlab programming hybrid engine operation Xiangjie, the main function is introduced and there is an instance of program)
- 2009-10-10 12:21:42下载
- 积分：1
-
Aircraft-inertial-navigation-control-system-desig
Aircraft inertial navigation control system design and simulation platform implementations
- 2012-04-18 13:46:01下载
- 积分：1
-
Ch_RTT_TWT_UTD
功能：该程序用于仿真时间同步算法双向不等时间同步方法与无时漂往返校时方法（RTT）。输入：节点间距离、钟漂。输出：两幅同步误差比对图。(Features: The program for the simulation of two-way time synchronization algorithm for time synchronization methods ranging from no time when the drift from school method (RTT). Input: the distance between nodes, clock drift. Output: two synchronization errors of the map.)
- 2010-08-16 10:51:22下载
- 积分：1
-
high
连续发酵罐控制器的matlab仿真设计 高浓度的一篇(Continuous fermentation tank controller matlab simulation design a high concentration)
- 2011-05-18 14:28:43下载
- 积分：1
-
pm-suanfa
内容：空间目标识别，采用PM算法。程序中附有注释，可以改变方向角，运算速度比music算法快，本人毕设程序，绝对可用。(Content: space target recognition using PM algorithm. Annotated program, you can change the direction of the angle calculation algorithm is faster than the music, I set up the program, absolutely free.)
- 2013-11-25 21:39:51下载
- 积分：1
-
qam16_4
qam-16 modulation. Simulink.
- 2009-05-03 14:11:20下载
- 积分：1
