-
fdtd1D
基于matlab的一维时域有限差分程序，使学习时域有限差分方法的好资料。(Matlab-based one-dimensional finite difference time domain procedure, so that learning FDTD good information.)
- 2007-11-26 20:05:23下载
- 积分：1
-
matlab1
matlab关于自动控制的编程，有源代码(failed to translate)
- 2009-05-23 13:57:47下载
- 积分：1
-
hengjia
计算一个平面桁架结构的总体刚度矩阵，最后以图形形式显示出桁架结构(Calculation of a plane truss structure' s overall stiffness matrix, the last show in graphical form of truss structure)
- 2011-06-07 22:09:20下载
- 积分：1
-
PLS
偏最小二乘法，能很好建立物质浓度和与相应的光谱矩阵的回归方程，且能对光谱阵降维和消除噪声影响。(Partial least squares, to establish material concentration and good with the regression equation of the corresponding spectral matrix array dimensionality of the spectrum and can eliminate noise effects.
)
- 2013-10-03 23:18:34下载
- 积分：1
-
rwg1
Antenna and EM Modeling with MATLAB
- 2011-10-07 06:06:31下载
- 积分：1
-
plural-signals-fastICA-algorithm
复数信号的fastICA算法.希望对大家有所帮助哦(plural signals fastICA algorithm. We hope to help oh
)
- 2011-10-18 20:03:45下载
- 积分：1
-
solo_emd
罗列经验模态分解的程序包的功能，如何载入以及卸载经验模态工具箱(Listed empirical mode decomposition package, how to load and uninstall experience modal Toolbox)
- 2012-09-09 11:32:24下载
- 积分：1
-
abs_2_relay.mdl
Simulink block diagram of simple Antilock Braking System control
- 2013-02-27 17:35:30下载
- 积分：1
-
kd
说明： 根据前人研究成果可以证明，煤镜质组反射率各向异性对煤田构造特征具有指示意义，镜质组最小反射率可以指示构造主应力方向。然而，在实际测量中，如何得到真正的镜质组最大、最小反射率及其方位是其中的关键环节。利用现有的岩石有限应变椭球拟合方法进行镜质组反射率椭球体拟合不失为一种行之有效的方法，可以由此确定镜质组最大、最小、中间反射率及其三维空间方位。
将之前拟合得到的反射率椭圆看作岩石有限应变椭圆即二维应变，其由之前的统计方法测定得到，三个截面的数据对于拟合唯一应变椭球来说是过多的，因此不可避免出现误差，导致三个截面应变椭圆不通过同一个椭球的情况。为了从三个截面数据得到唯一的应变椭球，需要对得到的数据进行相容性调整。采用Oertel的方法，从每一测量参数在不同截面中的值是正态分布这一假定出发，利用加权最小二乘法进行误差调整。(According to results of previous studies may prove vitrinite reflectance anisotropy on structural characteristics have implications for coal, vitrinite reflectance may indicate tectonic minimum principal stress directions. However, in actual measurement, how to get real vitrinite maximum, minimum reflectivity and its orientation is the key link. Conduct vitrinite reflectance ellipsoid fitting regarded as a proven method using existing rock finite strain ellipsoid fitting method can thus determine vitrinite maximum, minimum, intermediate reflectance and dimensional spatial orientation .
Before fitting the reflectance of finite strain ellipse oval rock that is seen as a two-dimensional strain, as determined by statistical methods which have been before the data fit only for the three sections of the strain ellipsoid is excessive, and therefore can not to avoid errors, resulting in three elliptical cross-section does not pass through the same strain ellipsoid situation. In order to obtai)
- 2014-11-12 11:06:13下载
- 积分：1
-
LSSVMLab-1.6
LS-SVM算法，最小二乘支持向量机算法matlab程序(LS-SVM algorithm)
- 2014-07-21 12:50:24下载
- 积分：1
|
联系客服（QQ：3324461878）
