-
Houghchange
HOUGH判断圆,根据判断直线的方法来改变的MATLAB程序，能在各种MATLAB下运行(USE HOUGH TO DETECT CIRCLE)
- 2009-05-13 17:30:05下载
- 积分：1
-
Project-System-Identification-submit
Project System Identification submit
- 2013-10-10 22:09:10下载
- 积分：1
-
WIMAXsource
WIMAX_WZ_withencoding:信道估计，相位噪声补偿，频偏估计，编解码都有
WIMAX_WZ_withoutencoding：在上面的工程基础上，去掉编解码部分
WIMAX_WZ_withoutprocessing：在上面的工程基础上，再去掉相位噪声补偿，频偏估计
WIMAX_WZ_withoutprocessing2：在上面的工程基础上，改用新的前导和导频联合信道估计方案,参考文档《基于802_16d标准的OFDM信道估计技术的研究与实现.kdh》
因为白噪声信道仿真只能体现QPSK调制和RS-CC编码的性能，需要仿真SNR可控的SUI信道，来估计信道均衡的性能。
在多普勒频偏fd>100Hz时，联合信道估计性能才比前导估计强，否则前导估计性能更优。对于600MHz中心频率，要求收发机相对运动速度大于180km/h，这种情况出现的概率不大(WIMAX_WZ_withencoding: channel estimation, phase noise compensation, frequency estimation, the codec has WIMAX_WZ_withoutencoding: the project on the basis of the above, remove the codec section WIMAX_WZ_withoutprocessing: the project on the basis of the above, then remove the phase noise compensation, offset estimation WIMAX_WZ_withoutprocessing2: In the project on the basis of the above, use the new leader and pilot joint channel estimation scheme, the document " Standards-based 802_16d OFDM channel estimation and implementation of technology .kdh" because white noise channel simulation only reflects the QPSK modulation and RS-CC coding performance requires simulation SNR controllable SUI channel, to estimate the performance of channel equalization. When Doppler shift fd> 100Hz, joint channel estimation performance was stronger than the leading estimate, otherwise better estimation performance leader. For 600MHz center frequency transceiver requirements relative velocity )
- 2015-03-25 09:14:02下载
- 积分：1
-
MATLAB
这是关于用MATLAB实现遗传算法程序的原理介绍，包括也选择、交叉、变异等算子的程序。(This is about using MATLAB genetic algorithm program to achieve the principle of description, including also selection, crossover and mutation operators of the program.)
- 2010-12-10 11:31:26下载
- 积分：1
-
批量读取JRA55数据.docx
说明： 批量读取JRA55数据，并循环将其插值到站点数据(Read jra55 data in batch and interpolate it to site data circularly)
- 2021-04-27 10:18:44下载
- 积分：1
-
robot
A model for robot in matlab/simulink using an s-function.
- 2010-05-09 17:07:45下载
- 积分：1
-
Read-header-vf
读取多普勒雷达资料，本程序对SA型天气多普勒雷达原始体扫数据进行处理(the process of the SA-Doppler weather radar on the original scan data processing, the use of radar data for the original subsequent handling )
- 2012-08-02 09:02:58下载
- 积分：1
-
MATLABfirdesign
matlab 设计 FIR 低通滤波器的几种方法(matlab design FIR low-pass filter of several methods)
- 2008-05-30 10:13:19下载
- 积分：1
-
SimuForFMJP
跳频信号是新的通信与雷达信号的一种，其保密性强，不易受噪声干扰，但解调复杂。本程序给出了高斯白噪声情况下调频信号的模拟过程，供通信和雷达专业的师兄弟参考。这是本文论文一部分的程序(FH signal is a new kind of communications and radar signals, and its confidentiality, less susceptible to noise interference, but the demodulation complexity. This procedure gives the Gaussian white noise process of FM analog signals for communication and radar fellow professional reference. This is a part of this thesis, the procedures)
- 2010-12-13 12:14:07下载
- 积分：1
-
RK-block
分块RK法求解一介偏微分方程的matlab程序，参数自己设计即可，包括自己设定的函数。(Block RK method for solving partial differential equations ordinary matlab program, the parameters can be of their own design, including its own set of functions.)
- 2013-10-20 13:20:56下载
- 积分：1
