-
DSPview4
a fifth version of Dsp view code in matlab
- 2013-10-31 18:34:11下载
- 积分：1
-
calculate_stenosis_loudness
说明： 基于ISO532A计算响度；播放声音；倍频程声压级计算(Calculation of loudness, playing sound, octave sound pressure level based on iso532a)
- 2020-04-15 17:17:59下载
- 积分：1
-
zhenliefangxiangtupiancha
阵列信号对于天线阵设定的频率有偏差的情况下的方向图效果
(Array signal to the antenna array to set the frequency deviation case pattern effect)
- 2012-04-26 16:06:37下载
- 积分：1
-
Jamming_NFM_Produce
根据干信比调节，生成指定带宽的调频噪声，产生噪声调频信号(According to the dry letter than regulation, to generate a specified bandwidth FM noise, noise FM signal)
- 2021-02-22 20:39:40下载
- 积分：1
-
monteGarlo
Monte Garlo 仿真程序，关于误码率与信噪比的对应关系，希望对大家学习有所帮助(Monte Garlo simulation program, on the bit error rate and signal to noise ratio of the corresponding relations and hopes to help them to learn)
- 2007-12-04 11:21:41下载
- 积分：1
-
MATLABimagecompression
共7个matlab程序及两幅原始待处理图像，功能是图像压缩的实验，分别运用了DCT（1个程序），小波变换（5个程序）和小波包变换（1个）对图像进行压缩，各个程序的作用及程序注释已在程序中做了详细说明,程序均可直接运行(matlab program for image compression ,using DCT wave,wavelet,wavelet packet methods respectively .)
- 2010-11-08 16:16:55下载
- 积分：1
-
2DPCA
无需把图像转换成向量形式，而是将图像看成是矩阵形式，大大减少了计算量。(Without the need to convert images to vector form, but the image as a matrix form, greatly reducing the amount of calculation.)
- 2010-05-05 16:47:05下载
- 积分：1
-
plot_hht_3d
matlab绘制三维Hilbert谱程序，保证可用。上传文件采用的是.txt形式，实际使用时只需要将后缀改为.m即可在matlab中运行。(matlab draw three-dimensional Hilbert spectrum procedures to ensure that available. Upload file uses a .txt form, the actual use of the suffix to .m only need to be run in matlab.)
- 2021-05-12 19:30:03下载
- 积分：1
-
cacode
Hi
I like to integrate GPS and INS using kalman filter to predict the
position of a vehicle.
first of all i like to use GPS sensor readings with kalman filter .
I have read lot of research papers for that purpose but I donot know how
to use real time data of GPS sensor in the kalman filter measurement
equation.
My question is that where i have to put the readings the gps sensor
in measurement equation i.e where to put numerical values the sensor
in the measurement equation.how these values make sense.
zk=Hxk+wk
also i like to ask as how can i determine the state transition matrix F
and observation matrix H for a particular application.
also how can i determine the measrement noise matrix the gps sensor.
thanks and regards
- 2014-11-02 11:45:21下载
- 积分：1
-
wsns-based-on-weighted-median
传感器节点故障诊断，分布式WMFD故障诊断算法，基于相邻节点信息比较的诊断方法(Distributed sensor network fault detection based on weighted median
)
- 2021-03-11 14:09:25下载
- 积分：1
