登录
首页 » matlab » kalman1

kalman1

于 2012-09-19 发布 文件大小:3KB
0 258
下载积分: 1 下载次数: 2

代码说明:

  卡尔曼滤波器的实现,对两个参量进行了滤波分析,效果比较理想(Realization of the Kalman filter, the filter of two parameters, the effect is more ideal)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • sa_tsp
    tsp旅行商问题,简洁的程序,适合学习。由MATLAB编写TSP旅行商问题
    2009-03-28 15:34:48下载
    积分:1
  • OFDMA_Data_mapping
    基本的WIMAX802.16d MAC层的实现,注意只仿真了下行 (Basic WIMAX802.16d MAC layer realize and pay attention only to the downlink simulation)
    2008-03-27 11:53:42下载
    积分:1
  • okumura-hata-model-implementation
    OKUMURA-HATA MODEL using MATLAB program.
    2012-07-17 10:10:43下载
    积分:1
  • cdma_ofdm_ESE
    A Hybrid Orthogonal Frequency Division Multiplexing & Code-Division Multiple-Access (OFDM-CDMA) This is a simulation program for uncoded OFDM-CDMA system with QPSK modulation and Complex channel modelled by Rayleigh fading. The program is modified based on Iterative chip-by-chip multi-user detection has been adopted in this simulation
    2015-01-23 04:12:40下载
    积分:1
  • BioReactor
    Good program treating biorector
    2013-05-03 18:26:29下载
    积分:1
  • 项目4
    说明:  任务:设计一个4×2.5Gbit/s 长距离光纤传输系统,并利用OptiSystem 仿真验证。 要求: 1.采用波分复用技术,波长设置以100GHz 为间隔,频率分别为193.1THz、193.2THz、193.3THz、193.4THz,每个波长传输速率为2.5Gbit/s(NRZ),传输距离为300km。采用常规光纤,光纤损耗系数为0.25dB/km。 2.单通道光发送机最大输出功率为0dBm,光接收机的接收光功率不低于-26dBm,过载点为-10dBm。 3.可以采用EDFA 作为线路放大器,其中EDFA 的输入功率限制在-18~2dBm,最大输出功率20dBm,增益范围为13~25dB,噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify. Requirement: 1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km. 2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm. 3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)
    2019-05-13 09:39:41下载
    积分:1
  • ex5_18
    说明:  在MATLAB环境下用PM算法进行的带通滤波器设计(In the MATLAB environment using the PM algorithm bandpass filter design)
    2008-11-18 19:20:35下载
    积分:1
  • 2D-Steger-Warming-Cylinder
    求解二维圆柱绕流问题,涉及坐标变换,还有通量分裂,在变坐标系下直接数值模拟ns方程二维情况(Solving two-dimensional circular cylinder flow problem, involving the coordinate transformation, flux splitting, direct numerical simulation ns Fang Cheng Erwei situation in the change of coordinate system)
    2012-05-29 23:16:12下载
    积分:1
  • GML_AdaBoost_Matlab_Toolbox_0.3
    adaboost算法代码可以在matlab中运行等等。。。。。。。。。。。(adaboost algorithm code)
    2014-01-27 16:09:18下载
    积分:1
  • high-speed railway
    机器学习简介,特别的时候新手查看,受益匪浅。上传于2017年底,简单易懂。(machine learning method. introduced the CNN basic idea and how to use it and when to use it. Very useful for new guys)
    2017-10-03 17:11:18下载
    积分:1
  • 696518资源总数
  • 106227会员总数
  • 11今日下载