登录
首页 » matlab » 2D-band-gap

2D-band-gap

于 2014-12-09 发布 文件大小:5KB
0 95
下载积分: 1 下载次数: 49

代码说明:

  二维声子晶体带隙计算,XY色散关系计算,matlab编程(Two dimensional phononic crystals bandgap calculation, calculation of XY dispersion relation, matlab programming)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • GridStorageBatt
    GRID STORAGE BATTERY
    2013-01-09 02:23:06下载
    积分:1
  • louyufangzhen
    一般楼宇信号衰减模型的仿真 其中带有界面支持鼠标操作(normal signal attenuation model simulation which interface with mouse support operation)
    2007-04-09 17:13:16下载
    积分:1
  • Dynamic_AS_Simulation_V2
    To calculate the coupling partitial difference equation of heat transition and diffusion.
    2011-09-21 23:08:31下载
    积分:1
  • MDS_basic
    可以根据图中点的位置判断连接关系,然后搜寻图中的MDS(最小支配集合)(You can determine the connection between the position according to FIG midpoint, then search graph MDS (Minimum Dominating Set))
    2014-01-15 14:23:53下载
    积分:1
  • nmealineread
    matlab檔案,用於讀取nmea檔案,將NMEA檔案輸出成一個Class架構值(read and parsing NMEA file)
    2014-02-21 10:21:42下载
    积分:1
  • MIMO_ZF
    mimo 信道仿真时均衡器的实现与仿真 性能分析(simulation of the ZF/MMSE equalizer for mimo channel model)
    2009-05-17 18:00:13下载
    积分:1
  • chuandianzutiaosu
    三相异步电机串电阻调速,matlab版本为 6.5(Three-phase induction motor speed control resistor string)
    2009-05-25 17:52:53下载
    积分:1
  • music
    在程序中用一般的MUSIC方法估计了信号的频谱,从两图中可看出在信号各频率处,频谱的峰值较大,故能明显的与噪声相区别,可在一定程度上避免在信号幅度较小时信号被噪声淹没的情况。(MUSIC method general procedures used to estimate the spectrum of the signal, it can be seen from the two graphs in the signal at each frequency of the spectrum peak larger, and it could be significantly distinguished from noise in the signal can be avoided to some extent a lesser extent, the signal is noise submerged.)
    2013-01-06 21:36:41下载
    积分:1
  • resident_characteristic
    邹鹏2011.6月论文中对于雷达重频模式鉴定提出的驻留比特性的仿真(Zou Peng 2011.6 paper for radar pulse repetition frequency mode identification characteristics reside than simulation)
    2013-01-11 11:58:57下载
    积分:1
  • matlab99999999
    各种matlab代码,实现各种功能,供查阅者参考,熟悉matlab软件的使用(x=linspace(0,1,21) y=linspace(0,1,21) [X,Y]=meshgrid(x,y) z=(X.*Y)./(X+Y) meshc(X,Y,z) )
    2011-07-11 15:54:13下载
    积分:1
  • 696518资源总数
  • 104349会员总数
  • 32今日下载