登录
首页 » matlab » power

power

于 2013-04-03 发布 文件大小:11KB
0 195
下载积分: 1 下载次数: 10

代码说明:

  大电网潮流计算的牛顿拉夫逊算法,MATLAB程序 (Large grid flow calculation Newton Raphson algorithm, MATLAB program)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Raporlar
    biyomedikal dersi iç in yapı lmı ş matlabta eeg siyallerinin incelenmesini anlatan bir projedir.
    2010-02-18 03:01:46下载
    积分:1
  • GeneratingPriors
    Code for generate priors.
    2013-03-27 03:17:35下载
    积分:1
  • MUSIC
    此程序为经典的MUSIC算法源程序,对经典算法使用MATLAB语言进行具体准确描述(This program is the classic MUSIC algorithm source code, the language of the classical algorithm used for specific and accurate description of MATLAB)
    2010-10-21 21:27:48下载
    积分:1
  • fiberfwm
    基于HNLF的全光逻辑与门主程序,光纤中的四波混频过程的matlab数值模拟仿真代码。(HNLF-based all-optical logic gates main program, fiber four-wave mixing process matlab numerical simulation codes.)
    2020-07-10 16:18:55下载
    积分:1
  • xianzhen_fuxiangwucha
    通过幅相误差存在的情况下MUSIC谱峰与未存在幅相误差时的比较,可以看出幅相误差对DOA估计还是有很大的影响。此程序中加入的幅相误差参数服从高斯分布(Through the case of amplitude and phase errors exist MUSIC peaks when compared with the amplitude and phase error does not exist, it can be seen amplitude and phase errors have a lot of influence on DOA estimates. Amplitude and phase errors of the parameters of this program by adding Gaussian distribution)
    2021-04-10 23:18:58下载
    积分:1
  • genetic-annealing-algorithm
    matlab常用算法,遗传退火算法,源程序(matlab commonly used algorithm, genetic annealing algorithm, source code)
    2012-05-02 13:11:08下载
    积分:1
  • autocorrelation
    自相关信号检测仿真程序。在数据处理过程中,首先要检测信号的存在和大致位置。(Self-related signal detection simulation program. In the data processing, the first to detect the presence and approximate location of the signal.)
    2013-01-05 18:14:51下载
    积分:1
  • Dolph_Chebyshev
    切比且夫线阵幅度加权方向图计算,画出二位方向图,图示中标示出增益,副瓣电平等(Ratio and the linear amplitude weighted directional graph computation, draw two direction map, marked gain the diagram, the sidelobe level etc. )
    2013-11-21 12:40:25下载
    积分:1
  • new1
    boost电路matlab仿真,输入为带有波动的直流电压 要求占空比为0.5(boost current road)
    2013-05-17 17:54:21下载
    积分:1
  • GPSsignalgeneration
    利用Matlab生成GPS C/A 码的基带信号。 (1)产生卫星PRN 号码为“5”的一组C/A 码; (2)循环生成25 页的导航数据,GPS 时间可填入一固定的已知数值; (3)生成C/A 码扩频信号,每个C/A 码码片给出4 个采样数据; (4)基带信号采用方波信号,电平为0 和1,占空比为50 %, 不加入噪声,进一步生成某个特定的中频信号(The baseband signal is generated using Matlab GPS C/A code. (1) generate satellite PRN number " 5" is a set of C/A code (2) loop generates 25 navigation data, GPS time can be filled with a fixed known value (3) generated C/A code spread spectrum signals, each C/A code chip sample data is given 4 (4) a baseband signal using a square wave signal with a level of 0 and a duty cycle of 50 , the noise was not added, and further generates a a specific frequency signal)
    2014-03-14 15:32:26下载
    积分:1
  • 696518资源总数
  • 106227会员总数
  • 11今日下载