-
segment
交互式选取生长起始点，将感兴趣部分分割出来。(Select starting point for interactive growth, will be interested in part from it.)
- 2010-08-13 14:50:29下载
- 积分：1
-
noiseest_matlab
NoiseLevel estimates noise level of input single noisy image. ... In the matlab code, I did not use the toeplitz matrix to calculate the
- 2014-08-19 19:27:44下载
- 积分：1
-
code
基于神经网络的人类polya位点识别。。。。。(neural network)
- 2013-05-09 20:08:14下载
- 积分：1
-
interpolare_lagrange
Interpolation using Lagrange
- 2010-06-08 01:50:04下载
- 积分：1
-
fft&conv
快速傅立叶变换和圆周卷积的通用MATLAB源程序,非常有参考价值(Fast Fourier Transform and Convolution circumference generic MATLAB source code, very useful)
- 2006-06-19 08:56:33下载
- 积分：1
-
ofdm_jida
信道模型包括模拟多径造成的指数衰减模型、模拟噪声干扰的 AWGN模型、以及频率偏差，主要 Matlab 实现(Channel model including the simulation of multipath caused by the exponential decay model to simulate the noise of the AWGN model, and the frequency deviation, the main Matlab Implementation)
- 2010-05-18 20:58:04下载
- 积分：1
-
attachments_2010_10_25
Vérification Méthode Media
- 2011-04-23 03:55:58下载
- 积分：1
-
PMSM_VC
永磁同步电机矢量控制的matlab仿真，测试波形完全正确(The permanent magnet synchronous motor vector control of matlab simulation, test waveforms completely correct)
- 2012-04-01 13:56:59下载
- 积分：1
-
teste_com_2
A simple test of RS232 communication between a computer and a surgical light dimmer
- 2014-01-15 21:33:52下载
- 积分：1
-
FiberGratingSpectra
传输矩阵法计算啁啾光栅反射谱
本节中给出传输矩阵法计算啁啾光栅反射谱和
时延的完整M at lab 程序实例, 本段代码在
M at lab513 和W indow s2000 环境中运行通过。运行结果如图8 所示。可以改变光栅长度、有效折射率、折射率调制深度、啁啾系数等参数来获得不同参数下光栅反射谱和时延曲线。如果打开“％ 切趾”行的屏蔽符“％ ”则可得到切趾后光栅反射谱和时延特性曲线, 此时计算所得的曲线将比图8 中所示的曲线平滑很多。(Transfer matrix method to calculate reflection spectrum of chirped grating is given in this section transfer matrix method to calculate chirped grating reflection spectrum and the delay of a complete example of M at lab procedures, the above code in M at lab513 and W indow s2000 environment to run through. The results shown in Figure 8. Can change the grating length, the effective refractive index, refractive index modulation depth and chirp coefficient parameters to obtain different parameters of grating reflection spectrum and the time delay curve. If you open Apodization line shielding Fu can be grating after apodization reflection spectrum and the delay characteristic curve, the curve at this time will be calculated as shown in Figure 8 a lot of curve smoothing.)
- 2008-12-20 15:07:24下载
- 积分：1
